Shurflo 134-0000-CG Installation Manual

INSTALLATION INSTRUCTIONS

OEM Version

Attention Manufacturers

Please include this Installation

Instruction sheet with your Owner’s

Documentation.

1

(1) Hold elbow on the wall where desired. Make sure to leave enough room for the hose to hang

freely and extend into the shower. Drill 1” hole in the bulkhead in the desired location.

(2) Make sure male nipple is tight into the elbow with Teflon (Plumber’s) tape. Slip nipple through the

hole in the bulkhead. Make sure gasket properly lines up with the back of the elbow. From the
back side of the bulkhead, thread the lock nut onto the brass nipple and tighten.

2

(3) Connect water supply lines (not provided) to the nipple. Wrap the end of the nipple with Teflon

(Plumber’s) tape. Follow the appropriate steps depending on your water supply lines. If you have
a pre-assembled water supply hose with a threaded connector, simply screw on supply hose. If
you have plastic water lines with formed ends, water line will seat partially up into the brass
nipple. Connect by tightening the coupling nut. We do NOT suggest using sweat fittings as they
are prone to blow-outs.

3

(4) Hold the bottom post on the wall where desired. With a pencil, lightly trace a circle completely

around the base of the post. Remove the post. Hold a mounting bracket directly in the center of
the outline. Trace a circle around the mounting bracket and the two mounting screw holes.

:

134-0000-CG

Universal

Metal Shower Slide Bar

Chrome/Gold

(5) Mount the bracket as shown. For mounting into fiberglass or other solid surface, drill a 1/8"

4

5

6

starter hole and attach the bracket to the wall.

(6) Secure the post to the bracket with the set screw pointing away from the bar. Tighten the set

screw.

(7) For the top post, merely set the bar into the bottom post and hold the top post at the correct spot.

NOTE: Mount the top post "in" tightly so that there is no up and down movement of the bar. USE
A BUBBLE LEVEL TO INSURE THAT THE BAR IS STRAIGHT. Trace a
circle around the top post and mount (repeat steps 4-6).

(8) Attach your 1/2” hose to the connector. Turn the water supply on. While

water is running, check all connections for leaks. Connections may need re­tightening.

(9) To adjust the height of the holder rotate the knob 1/4 turn to unlock, adjust to

desired location and re-lock. You can also tilt the holder by rotating its head.

CAUTION: THIS IS NOT A SAFETY DEVICE.

DO NOT USE AS A GRAB BAR.

7

8

134-0000-CG

Universal

1

3

1) Mounting Bracket

Parts

2) Mounting Screws

4

2

5

10

15

11

3) Set Screw

4) Top Post

5) Bar

6) Holder

14

7) Knob

8) Soap Dish

9) Bottom Post

10) Sprayer Head

11) Washer

12

13

12) 72” Stainless Steel Hose

13) Washer

14) Elbow

15) Lock Nut

7

6

8

3

/4"

1

3

/4"

Metal Shower Slide Bar

Chrome/Gold

3

3

/4"

3

10"

1

3

/4"

1

1

/4"

2

3

/4"

1

/2"-14 NPSM

23"

1

6

/4"

9

1

3

/4"

3

3

/8"

PROPER FINISH CARE:

Your new accessory is protected by a clear-coat. To clean it, you only need to wipe it with a damp, soft cloth.
NEVER use any abrasive cleaners, steel wool, or chemicals, as they will harm the finish and void your warranty. If
the accessory will be installed in a salt-air environment (boat exterior), regular cleaning with gentle soap and
carnauba wax will prolong the life of the finish.

LIMITED WARRANTY

SHURflo Marine Grade Faucets & Accessories are guaranteed to be free from material and workmanship defects under normal use and service for a
period of three (3) years from the date of manufactured vessel for all indoor applications and two (2) years from the date of manufactured vessel for all
outdoor applications. This limited warranty will not apply to faucets or accessories that were improperly installed, misapplied, or incompatible with
components not manufactured by SHURflo. Faucet failure due to foreign debris is not covered under the terms of this limited warranty. SHURflo
will not warrant any faucet that is physically damaged, or altered outside the SHURflo factory. Warranty claims may be resolved by a SHURflo
service center. All returns are to be shipped with charges pre-paid. Package all returns carefully. SHURflo will not be responsible for freight
damage incurred during shipping to a service center. SHURflo's obligation under this warranty policy is limited to the repair or replacement of the
faucets & accessories. Faucets or accessories found not defective (under the terms of this limited warranty) are subject to charges to be paid by the
returnee for the testing and packaging of "tested good" units. Warranty returns will be shipped on a freight allowed basis. SHURflo reserves the
right to choose the method of transportation. SHURflo is not responsible nor will it reimburse for labor necessary to remove and reinstall a faucet or
accessory, if found defective. This warranty is only a representation of the complete Marine Products Limited Warranty outlined by Service Bulletin #1050.

SHURflo reserves the right to update specifications, prices, or make substitutions.

SHURflo*

5900-A Katella Ave.

Cypress, CA 90630

[phone] [phone]

FAX [phone]

Shipping: 5900-C Katella Ave.

Cypress, CA 90630

SHURflo East

52748 Park Six Court

Elkhart, IN 46514-5427

[phone] [phone]

FAX [phone]

http://www.shurflo.com

SHURflo Ltd.*

Unit 5 Sterling Park

Gatwick Road, Crawley

West Sussex, RH10 2QT

United Kingdom

[phone]

FAX [phone]

911-xxx-134-0000-CG

Rev. 5/04

© 2004, SHURflo