Shurflo 133-1005-NP Installation Manual

INSTALLATION INSTRUCTIONS

Your new SHURflo Marine Grade Faucet will
give you years of trouble-free performance.
Thank you for choosing SHURflo Marine
Grade Faucets. Please read these instructions
carefully before installing your new faucet. If
you have any additional questions about the
installation of this faucet, please feel free to
contact one of our friendly customer service
representatives at 1-800-854-3218.

133-1005-NP

Nautilus

Cast

Galley / Wet Bar Faucet

Brushed Nickel

1

2

3

4

(1) Turn off the water supply to your existing faucet (this procedure will vary depending on the

specific plumbing system installed on your boat). Cover the sink drain to prevent any small
parts or debris from falling in. Remove your existing faucet, taking care not to damage your
existing water lines. Clean sink area in preparation for new faucet.

(2) Screw both mounting bolts into the bottom of the faucet. One end of the bolt is slotted to

allow the use of a screwdriver to secure. Screw both connector hoses into the bottom of
faucet (note: it is NOT necessary to use Teflon (Plumber’s) tape on this connection as the
o-rings will prevent leaks). Use a wrench or pliers on the hex nut molded into the brass
shaft portion of the hoses. Do NOT attempt to tighten by turning the hose itself.

(3) Place your new faucet through the hole in your sink. Make sure the black gasket properly

lines up with the bottom of the faucet. From under the sink, slide the rubber horseshoe
washer then the metal horseshoe washer onto the mounting bolts. Adjust faucet position
on the sink as desired. Thread the lock nuts onto the mounting bolts and tighten. It may be
necessary to re-adjust the faucet position by slightly loosening the lock nuts, adjusting to
desired location, then re-tightening the lock nuts.

(4) Connect water supply lines (not provided) to the connector hoses. Wrap the brass fittings

on the connector hoses with Teflon (Plumber’s) tape. Follow the appropriate steps
depending on your water supply lines. If you have pre-assembled water supply hoses with
threaded connectors, simply screw on supply hose. If you have plastic water lines with
formed ends, water lines will seat partially up into the brass fittings. Connect by tightening
the coupling nuts. We do NOT suggest using sweat fittings as they are prone to blow-outs.

5

(5) After installation is complete, remove the aerator. Be careful not to scratch the finish. Turn

the water supply back on and allow both hot and cold water to run for at least one full
minute. While water is running, check all connections for leaks. Replace aerator.
Connections may need re-tightening.

133-1005-NP

Nautilus

Cast

Parts

1) Blue/Red Cap

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

6

22

2

5

4

2) Handle Screw

3) Nautilus Handle

4) Cap

5) Retainer Ring

6) Ceramic Disc Cartridge

7) Aerator

8) Spout

9) O-Ring

10) Spool

11) Packing Rings

12) Packing Ring

13) O-Ring

14) Packing Ring

15) Bonnet

16) Body

1

17) Gasket

18) Mounting Bolts

19) Rubber Horseshoe Washer

20) Metal Horseshoe Washer

21) Lock Nuts

3

22) Connector Hoses

From the galley to the head…
You can enjoy the entire Nautilus
family throughout your boat!

Galley / Wet Bar Faucet

Brushed Nickel

PROPER FINISH CARE:

Your new faucet is protected by a clear-coat. To clean it, you only need to wipe it with a damp, soft cloth. NEVER
use any abrasive cleaners, steel wool, or chemicals, as they will harm the finish and void your warranty. If the
faucet will be installed in a salt-air environment (boat exterior), regular cleaning with gentle soap and carnauba wax
will prolong the life of the finish.

LIMITED WARRANTY

SHURflo Marine Grade Faucets & Accessories are guaranteed to be free from material and workmanship defects under normal use and service for a period of
five (5) years from the date of purchase. This limited warranty will not apply to faucets or accessories that were improperly installed, misapplied, or
incompatible with components not manufactured by SHURflo. Faucet failure due to foreign debris is not covered under the terms of this limited warranty.
SHURflo will not warrant any faucet that is physically damaged or altered outside the SHURflo factory. Warranty claims may be resolved by a SHURflo
service center. All returns are to be shipped with charges pre-paid. Package all returns carefully. SHURflo will not be responsible for freight damage
incurred during shipping to a service center. SHURflo's obligation under this warranty policy is limited to the repair or replacement of the faucets &
accessories. Faucets or accessories found not defective (under the terms of this limited warranty) are subject to charges to be paid by the returnee for the
testing and packaging of "tested good" units. Warranty returns will be shipped on a freight allowed basis. SHURflo reserves the right to choose the method
of transportation. SHURflo is not responsible nor will it reimburse for labor necessary to remove and reinstall a faucet or accessory if found defective. This
warranty is only a representation of the complete Marine Products Limited Warranty outlined by Service Bulletin #1050.

SHURflo reserves the right to update specifications, prices, or make substitutions.

SHURflo*

5900-A Katella Ave.

Cypress, CA 90630

[phone] [phone]

FAX [phone]

Shipping: 5900-C Katella Ave.

Cypress, CA 90630

[phone] [phone]

SHURflo East

52748 Park Six Court

Elkhart, IN 46514-5427

FAX [phone]

http://www.shurflo.com

SHURflo Ltd.*

Unit 5 Sterling Park

Gatwick Road, Crawley

West Sussex, RH10 2QT

United Kingdom

[phone]

FAX [phone]

© 2004, SHURflo