Shurflo 130-0027-CP Installation Manual

INSTALLATION INSTRUCTIONS

OEM Version

Attention Manufacturers

Please include this Installation

Instruction sheet with your Owner’s

Documentation.

:

130-0027-CP

Universal

Pop-Up Drain

Without Overflow

Chrome

1

2

3

4

5

(1) Unscrew flange from drain body. Leave large black washer, white friction ring and locknut on

drain body.

(2) Place a ring of putty around the drain hole in your sink. Insert the threaded end of the drain

body up through the drain hole and attach the flange to the body, with the pivot ball nut pointing
to the rear of the sink.

(3) Tighten the locknut from under the sink until the black rubber washer seats securely inside the

sink drain hole. Wipe away excess putty. Tighten brass locknut with a wrench.

(4) Set the drain plunger in place (see “Drain Plunger” below). Unscrew the pivot ball nut from the

pop-up body and remove the spring clip from the pivot ball rod. Leave the white packing ring on
and slide the ball nut onto the rod covering the white packing ring. Insert the rod into the hole
on the back of the pop-up body. Slide the ball nut in place and tighten securely.

(5) Slide one end of the spring clip onto the end of the pivot rod. Insert the pivot rod into one of the

lower holes in the lift rod strap. Secure other end of spring clip onto pivot rod.

(6) Slide lift rod down through the hole in faucet. Insert bottom of lift rod into hole on the top of the

lift rod strap (see “Adjusting The Lift Rod” below). Tighten with thumb screw.

6

Adjusting The Lift Rod

Adjust lift rod function by adjusting the
height of the thumb screw along the lift rod
(step 6) or by changing the hole that the
pivot rod goes through on the lift rod strap
(step 5). Be sure to leave enough space
between the lift rod knob and the faucet
spout when the rod is down.

Drain Plunger

There is a small square cutout at the
bottom of the drain plunger. That square
needs to go down the front of the drain
body (opposite side from the pivot ball nut).
The pivot rod passes through that square
to lock the drain plunger in and form a tight
seal when drain is closed.

130-0027-CP

Universal

Pop-Up Drain

1

2

3

10

4

5

6

7

8

11

1) Stopper

2) O-Ring

3) Plunger

4) Flange

5) Black Washer

6) Friction Ring

7) Lock Nut

8) Body

9) Tail Pipe

10) Lift-Rod Knob

11) Lift-Rod

12) Thumb Screw

13) Lift-Rod Strap

14) Spring Clip

15) Pivot Rod

16) Pivot Ball Nut

17) Packing Ring

18) Packing Ring

12

Parts

1

3

/

4

" Max

2

1/

8

"

1

1/

2

"

Without Overflow

Chrome

8

3

/

8

"

18

17

16

15

9

13

14

4"

1

1/

4

"

PROPER FINISH CARE:

Your new accessory is protected by a clear-coat. To clean it, you only need to wipe it with a damp, soft cloth.
NEVER use any abrasive cleaners, steel wool, or chemicals, as they will harm the finish and void your warranty. If
the accessory will be installed in a salt-air environment (boat exterior), regular cleaning with gentle soap and
carnauba wax will prolong the life of the finish.

LIMITED WARRANTY

SHURflo Marine Grade Faucets & Accessories are guaranteed to be free from material and workmanship defects under normal use and service for a
period of three (3) years from the date of manufactured vessel for all indoor applications and two (2) years from the date of manufactured vessel for all
outdoor applications. This limited warranty will not apply to faucets or accessories that were improperly installed, misapplied, or incompatible with
components not manufactured by SHURflo. Faucet failure due to foreign debris is not covered under the terms of this limited warranty. SHURflo
will not warrant any faucet that is physically damaged, or altered outside the SHURflo factory. Warranty claims may be resolved by a SHURflo
service center. All returns are to be shipped with charges pre-paid. Package all returns carefully. SHURflo will not be responsible for freight
damage incurred during shipping to a service center. SHURflo's obligation under this warranty policy is limited to the repair or replacement of the
faucets & accessories. Faucets or accessories found not defective (under the terms of this limited warranty) are subject to charges to be paid by the
returnee for the testing and packaging of "tested good" units. Warranty returns will be shipped on a freight allowed basis. SHURflo reserves the
right to choose the method of transportation. SHURflo is not responsible nor will it reimburse for labor necessary to remove and reinstall a faucet or
accessory, if found defective. This warranty is only a representation of the complete Marine Products Limited Warranty outlined by Service Bulletin #1050.

SHURflo reserves the right to update specifications, prices, or make substitutions.

SHURflo*

5900-A Katella Ave.

Cypress, CA 90630

[phone] [phone]

FAX [phone]

Shipping: 5900-C Katella Ave.

Cypress, CA 90630

SHURflo East

52748 Park Six Court

Elkhart, IN 46514-5427

[phone] [phone]

FAX [phone]

http://www.shurflo.com

SHURflo Ltd.*

Unit 5 Sterling Park

Gatwick Road, Crawley

West Sussex, RH10 2QT

United Kingdom

[phone]

FAX [phone]

911-xxx-130-0027-CP

Rev. 7/04

© 2004, SHURflo