Shure orporated ADX1G57, ADX1K54, ADX1X55 Users manual

AXIENT® DIGITAL

ADX1 Axient Digital Bodypack Transmitter

USER GUIDE

© 2017 Shure Incorporated
27A33410 (Rev. Preliminary)
Printed in U.S.A.

WARNING

• Battery packs may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140°F (60°C), or
incinerate.

• Follow instructions from manufacturer

• Only use Shure charger to recharge Shure rechargeable batteries

• WARNING: Danger of explosion if battery incorrectly replaced. Replace only with same or equivalent type.

• Never put batteries in mouth. If swallowed, contact your physician or local poison control center

• Do not short circuit; may cause burns or catch fire

• Do not charge or use battery packs other than Shure rechargeable batteries

• Dispose of battery packs properly. Check with local vendor for proper disposal of used battery packs.

• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like

Note: Use only with the included power supply or a Shure-approved equivalent.

Please follow your regional recycling scheme for batteries, packaging, and electronic waste.

WARNING: This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.

低功率電波輻射性電機管理辦法

第十二條

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電
信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

IMPORTANT SAFETY INSTRUCTIONS

1. READ these instructions.

2. KEEP these instructions.

3. HEED all warnings.

4. FOLLOW all instructions.

5. DO NOT use this apparatus near water.

6. CLEAN ONLY with dry cloth.

7. DO NOT block any ventilation openings. Allow sufficient distances for adequate ventila­tion and install in accordance with the manufacturer’s instructions.

8. DO NOT install near any heat sources such as open flames, radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat. Do not place any open
flame sources on the product.

9. DO NOT defeat the safety purpose of the polarized or groundingtype plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two blades
and a third grounding prong. The wider blade or the third prong are provided for your
safety. If the provided plug does not fit into your outlet, consult an electrician for replace­ment of the obsolete outlet.

10. PROTECT the power cord from being walked on or pinched, particularly at plugs, conve­nience receptacles, and the point where they exit from the apparatus.

11. ONLY USE attachments/accessories specified by the manufacturer.

12. USE only with a cart, stand, tripod, bracket, or table specified by the manu­facturer, or sold with the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.

13. UNPLUG this apparatus during lightning storms or when unused for long
periods of time.

14. REFER all servicing to qualified service personnel. Servicing is required when the ap­paratus has been damaged in any way, such as power supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.

15. DO NOT expose the apparatus to dripping and splashing. DO NOT put objects filled with
liquids, such as vases, on the apparatus.

16. The MAINS plug or an appliance coupler shall remain readily operable.

17. The airborne noise of the Apparatus does not exceed 70dB (A).

18. Apparatus with CLASS I construction shall be connected to a MAINS socket outlet with a
protective earthing connection.

19. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture.

20. Do not attempt to modify this product. Doing so could result in personal injury and/or
product failure.

21. Operate this product within its specified operating temperature range.

This symbol indicates that dangerous voltage constituting a risk of
electric shock is present within this unit.

This symbol indicates that there are important operating and mainte­nance instructions in the literature accompanying this unit.

WARNING: This product contains a chemical known to the State of California to cause cancer and birth

defects or other reproductive harm.

ADX1 Axient Digital Bodypack Transmitter

ADX series transmitters deliver impeccable audio quality and RF performance, and are equipped with ShowLink® remote control for real-time parameter
adjustments and interference avoidance. This transmitter features wide tuning, High Density (HD) mode, encryption, and advanced rechargeability in a
streamlined design. Light-weight aluminum construction, AAA or SB910 rechargeable power options (with lockable charging), and TA4 or LEMO3 con­nector options.

Features

Performance

• 184 MHz tuning range

• 20 Hz to 20 kHz range with flat frequency response

• Automatic input staging optimizes gain setting

• Diversity ShowLink-enabled for remote transmitter control and automat­ic interference avoidance

• AES 256-bit encryption-enabled for secure transmission

• >120 dB, A-weighted, System Gain @ +10

• Digital output: >125dB, A-weighted (Dante, AES3, AES67)

• 100 meter (300 feet) line-of-sight operating range

• Selectable modulation modes optimize performance for spectral
efficiency

- Standard – optimal coverage, low latency

- High density – dramatic increase in max system channel count

• Built-in tone generator and RF markers to facilitate walk-testing

• Switchable Power Levels = 2/10/40 mW (region dependent)

• Frequency Diversity selection using two bodypacks

Included Components

SB910 Shure Rechargeable Battery (2) 95A24832

¼ wave antenna Varies by Region

Transmitter carrying case WA610

Zipper bag 95A2313

Design

• TA4 or LEMO3 audio connector option

• Backlit LCD with easy to navigate menu and controls

• Durable, moisture-resistant, lightweight aluminum case

• Flexible ¼ wave antenna

• Menu and power lockout

Power

• Shure SB910 rechargeable batteries for up to 10 hours of runtime, pre­cision metering, and zero memory effect

• AAA-compatible battery sled available

• External charging contacts for docked charging

Optional Accessories

SB910 Shure Rechargeable Battery 95A24832

3 x AAA Battery Sled for ADX1 Transmitter SB913

AD651FOB Talk Switch fob for bodypack
transmitters

Replacement belt clip 44A12547

Shure Networked Docking Charger 2-Up SBC240

90A37348

4

ADX1 Transmitter Overview

Transmitter Controls

① RF Antenna

For RF signal transmission.

② Display

View menu screens and settings. Press any control button to
activate the backlight.

③ Control Buttons

Use to navigate through parameter menus and to change settings.

④ Battery Compartment

Requires Shure SB910 rechargeable battery.

⑤ Battery Door

Latching door to secure battery.

⑥ SMA Connector

Connection point for RF antenna.

⑦ Infrared (IR) Port

Align with the receiver IR port during an IR Sync for automated
transmitter tuning and setup.

⑧ Power Switch

Powers the unit on or off.

⑨ Power LED

- Green = unit is powered on

- Red = low battery, Mute Mode enabled, input overload, or battery error
(see Troubleshooting)

⑩ Input Jack

Connects to a 4-Pin Mini Connector (TA4F) microphone or
instrument cable.

Note: A LEMO connector model variation of this transmitter is available.

⑪ Battery Charging Contacts

Charging contacts for use with docking battery chargers.

Use the controls to navigate through parameter menus and change values.

X

O

∨∧ Use to scroll through menu screens and to change param-

Tip: Use the following control shortcuts for quick set up:

• Hold the ∧ button while powering-on to lock or unlock the transmitter

• Hold the X button while powering-on to set the transmitter RF output to mute

Acts as a 'back' button to return to previous menus or pa­rameters without confirming a value change

Enters menu screens and confirms parameter changes

eter values

Locking the Interface

Lock transmitter interface controls to prevent accidental or unauthorized chang­es to parameters. The lock icon is shown on the home screen when the inter­face lock in enabled.

1. From the Utilities menu, navigate to Lock and se­lect one of the following lock options:

- None: The controls are unlocked

- Power: The power switch is locked

- Menu: The menu parameters are locked

- All: The power switch and menu parameters are locked

2. Press O to save.

Tip: To quickly unlock a transmitter: Press O twice, select None, and press O.

Home Screen Display

The home screen shows transmitter information and status.

Tip: There are four options to choose the information shown on the home
screen. Use the arrow buttons to select one of the following choices:











10

• Name

• Frequency Setting

• Group (G) and Channel (C)

• Device ID

Shure

470.200MHz

7:45



The following icons appear to indicate transmitter settings:



11





Battery runtime in hours and minutes or bar display

Key: Displayed when encryption is enabled

Lock: Displayed when controls are locked. Icon will flash if ac­cess is attempted to a locked control (power or menu).

ShowLink signal strength displays 0 to 5 bars

STD: Standard Transmission Mode

HD: High Density Transmission Mode

Box: When the box has an "x", Mute Mode is on and engaged. If
the box is empty, Mute Mode is on, but not engaged.

5