Shure SA-10 User Guide

The vinyl surface of the Portable Solo-Phone Carrying

Case is scuff resistant and will not crack or peel in normal usage. All metal parts are plated, rust-proof and durable. The case may be cleaned with a damp, soapy cloth. Do not use solvents or ~trong detergents on the surface.

Securing the Record Changer for

Shorr Trips

See that changer has cycled to "OFF" position.

Place record spindles in appropriate clips.

Turn transit screws fully co~~nterclockwise to tighten changer against motorboard. When unit is put back into service, be sure to loosen transit screws so that table floats freely on its suspension.

Assemble stylus guard to the arm by means of hook on arm rest.

Coil power line cable holder.

Shipping Shure

Cioods damaged in transit because of inadequate packing for shipment cannot be covered by shipping insurance.

If it is found necessary to return unit for service, contact Shure Brothers, Inc., Service Department for shipping instructions.

Guarantee:

guaranteed to be free from electrical and mechanical defects for a period of one year from date of shipment from the factory, provided all instructions are complied with fully. In case of damage, it is essential that you carefully repack the unit and return it to the factory for

repair. Our guarantee is voided if the basic assembly has

been opened or subjected to unreasonably rough handling.

Patent Notice:

988: 3,077,521: and 3,077,522. Other patents pending.

27A384 (8-69)

Storage:

cartridge

sing

black plastic cable

SA-10

This Shure High Fidelity Component is

Manufactured ~inder U.S. Patents 3,055,-

to Service Department

lnc.

and secure

Printed in U.S.A

221

HARTREI

AYE

MICROPHONES AND ELECTRONIC COMPONENTS

FYANSTOH

MODEL SA-20 PORTABLE SOLO-PHONE'"

SYSTEM

The Shure Portable solo-~h%e System is of a four-speed record changer and a ereo ainpllfier specifically designed for high fidelity listening with headphones. The record changer and amplifier are enclosed in

an attractively styled, vinyl-covered wooden carrying cace.

The four speed record player:

Plays automatically up to eight records of 7,"

and

12"

diameter.

Selects correct record size with records mixed in any

order.

May be stopped and restarted without rejecting the

record being played.

May be used manually as a single record player.

The control knob on the record changer also turns the

anlplifier "On" and

Two stereo headphone jack5 are provided on the panel, permitting two set5 the same time.

"Ott

stcreo headphones to be used

P-

ILL

(6020.1)

mbination

10,"

To prepare the SA-10 Solo-Phone System for high fidelity enjoyment, proceed as follows:

Remove the plastic bag (from packaging insert) containing line cord, counter-balance weight, and spindles.

Carefully remove the cardboard packaging inserp by pulling (gently) straight up. Also, slowly remove the two cardboard strips wedged between turntable base and its mounting board.

Remove rubber band holding stylus guard to the cartridge. Do not remove stylus guard until ready to play records. Save stylus guard for future use when carrying or traveling with the Portable Phone System.

4. Open plastic bag (See Item balance and attached mounting screw. Install counter balance on the rear of the pickup arm.

Remove long and short spindles from plastic bag and insert into retaining clips at rear of the changer.

Turn the transit screws fully turntable base it riding freely on the suspension springs.

Unwind line cord. Save black plastic cable holder for future use in retaining and storing cable during transit.

and remove counter

clockwise

Solo-

until the

OPERATION

Plug the headphones into the jacks on the panel. The

volume control is a two-part control, allowing separate adjustment of each stereo channel to achieve proper balance between channels. Either channel may be adjusted by holding firmly one part of the control and turning the other part of the control to desired volume for that channel. After each chan-

nel has been adjusted, simple overall volume changes

INSTALLATION

can be made by control.

turning either part of the dual

Connect the Portable Solo-Phone System power

117

volt

lo%,

line cord to a outlet.

The

aniplifier is turned on when the record changer control switch is amplifier is automatically turned changer control switch is moved to Ia\t record is played.

See Garrard Model guide to proper operation and adjustliient of the four-\peed record changer and player.

moved to automatic or manual. The

In\tr~iction Sheet for a

cycle power

ofT when record

OFF

or after

Cartridge:

The SA-10 Portable Solo-Phone System uses the Shure M44C Stereo Dynetic Phono Cartridge which reproduces

music with remarkable clarity and naturalness of tone. The cartridge has been installed into the pickup arm head, at the factory. The stylus pressure has been preset at grams for optimum results. The stylus replacement for the Shure

M44C Cartridge is the Shure N44C.

The Shure N44-3 Stylus is available for use with the M44C Cartridge to reproduce the standard

SPECIAL NOTE: The these cartridges is the most critical component. To maintain the original performance standards of your cartridge, be certain that any replacement stylus you buy bears the following certification on the package: "This Stereo

DyneticN stylus is precision manufactured by Shure Brothers, Inc."

Avoid inferior imitations. They will seriously degrade the performance of your cartridge. are manufactured by Shure Brothers, Inc.

The stylus assembly, when installed in the cartridge, is practically immune to damage during normal usage. However, care should be taken to avoid bending or distorting the stylus assembly when it is installed or removed.

Dynetic stylus assembly used in

r.p.m. recordings.

All gen~~ine "Dynetic" styli

15"