Shure S39A, S37A User Guide

Model S39A Vibration/Isolation Stand

and S37A Desk Stand User Guide

MODEL S39A VIBRATION ISOLATION STAND WITH SWIVEL ADAPTER

The Model S39A Vibration Isolation Stand provides excellent
shock isolation, preventing floor or table vibrations from reaching a
mounted microphone. Use the S39A for sportscasting, conference
table or front-of-stage installations, or any application where
severe vibrations may occur.

INSTALLING MICROPHONES ON S39A

1. Mount lightweight microphones directly to the S39A.

2. Mount heavier microphones with bottom-entry cable connec­tors on the provided extension adaptor. The extension adapter
increases the amount of cable-connector clearance.

3. Fasten swivel adapters or extension adapters to the S39A with the supplied brass attachment screw.

4. Insert the screw through the bottom of the stand base and tighten with a large screwdriver.

5. To make adjustments, loosen the screw, adjust, then tighten the screw.

NOTE: Do not use the S39A with microphones weighing
over 1 kilogram (2.25 lbs.). Excessive weight reduces the
effectiveness of the isolation.

SPECIFICATIONS:

Weight: 964 g (2.125 lbs.)
Dimensions: See Figure 1

183 mm
7-3/16 IN

65.1 mm
2-9/16 IN

130 mm
5-1/8 IN

66.7 mm
2–5/8 IN

MODEL S37A DESK STAND

The Model S37A Desk Stand provides a low profile, stable base for microphones with swivel connector assemblies, or microphones using swivel adapters.

INSTALLING SWIVEL CONNECTOR ASSEMBLIES ON S37A (FIGURE 2):

1. Place the microphone in the recess at the top of the base.

2. Fasten the microphone to the base with the provided brass attachment screw.

3. Insert screw through the bottom of the base and tighten with a large screwdriver.

4. Insert the cable-connector plug into the microphone receptacle.

5. Place the cable in the groove in the bottom rear of the base.

6. Clamp the cable to the base using the provided clamping strip and machine screws.

NOTE: The supplied mounting plate is not used with
swivel connector assemblies.

USE WITH SWIVEL ADAPTERS (FIGURE 3):

1. Place the provided mounting plate in the recess at the top of the base.

2. Position the swivel adapter on top of the mounting plate so that the swivel adapter projection fits into the notch on the mounting plate. Secure it with the supplied brass screw.

3. Tighten the brass attachment screw with a large screwdriver.

SPECIFICATIONS:

Finish: Non-reflective gray
Weight: 691g (1.5 lbs)
Dimensions: See Figure 4

FIGURE

FIGURE 1

165 mm
6-1/2 IN

FIGURE 4

©2004, Shure Incorporated

27B848 (Rev. 4)

88.9 mm
3-1/2 IN

73 mm
2-7/8 IN

116 mm
4-9/16 IN

54 mm
2-1/8 IN

SWIVEL
CONNECTION

CABLE

SCREW

CONNECTION

SCREW

FIGURE 2

SHURE Incorporated Web Address: http://www.shure.com
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
In U.S.A., Phone: [phone] Fax: [phone]
In Europe, Phone: [phone] Fax: [phone]
In Asia, Phone: [phone] Fax: [phone]
International Fax: [phone]

FIGURE 3

Printed in U.S.A.

SWIVEL
ADAPTER

MOUNTING
PLATE

2