Shure R191 User Guide

27C3045 (Rev. 3)

27C3045 (Rev. 3)

A

e

–solder wires from pi

connector

using a soldering

With microphone in a secure position, de-solder

wires from pin connector (C) using a soldering iron

to damage rubber plug element.

2.

6.

t

dam

age

g

coil

wheg o c

asing

A

J

screwing on clockwise.

element

with

side

facing

cartridge.

element (H), and insert rubber plug element back into casing (G),

Rubber plug element should only

Thread wires through bottom of handle and reattach bottom of

NOTE:

If replacing cartridge

are approximately one inch longer than assembled handle. No

trimming is required for use with models SM63L or SM63LB.

as they can break if pinched.

x

G

COIL

YELLO

3

2.

6.

5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.

Asia, Pacific: