Shure M92E User manual
Cartridge
A
Stylus
M92E
Biradial (elliptical),
.4 x .7 mil
Specications
Stylus Grip
Color
Output (1 kHz
at 5 cm peak
Red 5.0 mV
recorded
velocity) †
18,000 Hz
Frequency
Response
20 to
Model M92E
Users Guide
Channel
Balance
Channel
Separation
Within
2 dB
20 dB
at 1
kHz
Tracking
Force*
0.75 to 1.5
grams
(1.25 grams
optimum)
N78S
78 rpm , spherical,
†Output voltages given for stereo cut record; for MONO cut record, output voltage
at both left channel and right channel cartridge terminals will be 71% of gure above.
*Do not exceed maximum indicated tracking force.
Green 4.0 mV
20 to
17,000 Hz
Mono Mono
1.5 to
3 grams
Optimum Load: 47,000 ohms resistance in parallel with 200 to 300 picofarads capacitance
per channel. Load resistance can be up to 70,000 ohms with almost no audible change in
frequency response. Total capacitance includes both tone arm wiring and amplier input
circuit.
Certication: Conforms to European Union directives, eligible to bear CE marking; meets
European Union EMC Immunity Requirements: EN 50 082-1, 1992.
Net Weight: 7.3 grams including standard 1/2 in. mounting adapter. Without adapter,
cartridge is compatible with pre-set P-Mount arm.
THIS CARTRIDGE FEATURES THE SHURE BIRADIAL NUDE DIAMOND TIP
Its contact area is longer and narrower
than the traditional spherical tip-groove
contact area. This results in dramatic
reduction of both harmonic distortion
and inter modulation distortion.
Stylus Cleaning
To clean the stylus, use a soft brush
with alcohol or an alcohol-distilled
water solution. Brush only from back to
front as shown. Commercial cleaning
solutions may cause stylus damage.
VIEW IN DIRECTION A
©2008, Shure Incorporated
27B2172 (Rev. 3)
Printed in U.S. A.
Mounting
A B
rouge
rojo
green
vert
grün
verde
red
rot
*
R L
RG LG
white
blanc
blanco
weiss
blue
bleu
blau
azul
C
Tracking Force in a P-Mount Arm
After installing the cartridge, it is not usually necessary to adjust the tracking force in a
pre-set arm.
Skating Compensation (where applicable)
Set the skating compensation mechanism according to the tone arm manufacturer’s
instructions.
To Preserve Stylus Life
Protect stylus with stylus guard when dusting turntable1.
Regulate tone arm set-down to prevent stylus from striking edge of turntable or record.2.
Do not handle tone arm while record is being played. Use cuing device if available.3.
If manual set-down is necessary, release arm as soon as stylus engages groove4.
Do not activate arm without record on turntable.5.
Do not use damaged records.6.
Make certain cartridge is correctly mounted in tone arm and stylus is properly inserted in 7.
cartridge.
Use appropriate vertical tracking force for each cartridge and stylus.8.
Loading...