Shure AXT610 Specification Sheet

Component Speciﬁcations

AXT610 ShowLink Wireless Access Point

Overview

The AXT610 ShowLink™ access point enables real-time remote control of the Axient™ transmitters. The access point allows comprehensive management of transmitter parameters from the receiver or Wireless Workbench 6 using 2.4 GHz wireless network communication. All parameter changes occur without interruption to the performer.

• Real-time wireless remote control of up to 16 transmitters per ShowLink access point

• Automated channel selection - Independently scans 2.4 GHz frequency range and determines best channel for use

• Receives power over Ethernet network connection or from an external power supply

• Easy transmitter authentication - Recognizes linked transmitters upon IR sync

• Provides a coverage area equivalent to the range of Axient transmitters

• Automatic hand-offs between multiple access points extend coverage range

• Automatic frequency agility - Moves a ShowLink network to the best available 2.4 GHz channel in the event of signal degradation

• Versatile mounting options - Fits readily available microphone stand adapters and features built-in threading for permanent installation

• Wireless Workbench

Product Specifications (subject to change)

Antenna Type Omnidirectional 2.4 GHz Capacity 16 Axient transmitters Mounting Type WA371 Mic Clip or 1/4-20 thread mount Operating Temperature Range -18°C (0°F) to 63°C (145°F) Storage Temperature Range -29°C (-20°F) to 74°C (165°F) Dimensions 186 mm x 101 mm x 46 mm (7.34 in. x 3.960 in. x 1.825 in.) H x W x D, without antenna Weight 476 g (16.8 oz.), without antenna Housing Extruded Aluminum Power Requirements Power over Ethernet (PoE) Class 1: 36 to 57 VDC/VAC

ShowLink

Network Type IEEE 802.15.4 Frequency Range 2.40 to 2.4835 GHz (16 Channels) RF Output Power 10 dBm (ERP) Working Range Under typical conditions: 150 m (500 ft)

Antenna Connection

Connector SMA (Shell=Ground, Center=Signal) Impedance 50 Ω

Scanning Radio

Scanner RF Sensitivity -106 dBm, typical (integrated antenna)

Networking

Network Interface Ethernet 10/100 Network Addressing Capability DHCP or Manual IP address (configurable using Wireless Workbench)

6 system supports networked control of all device functions and provides a ShowLink plot for viewing 2.4 GHz signal levels

External Power Supply (if PoE is unavailable): 15 V DC (600 mA), double insulated

Line of Sight, outdoors for a single system: 500 m (1600 ft) Note: Actual range depends on RF signal absorption, reflection and interference.

Axient Wireless

Showlink Acces Point

AXT610

ShowLink Wireless Access Point

Included Components

WA371 Wireless microphone clip for mounting on a microphone stand

31A1856 Euro thread adapter for WA371

C825 Shielded 25-foot Ethernet cable for ShowLink access point, RJ45-to-EtherCon connector

www.axient.net

www.shure.com