SHUOYING DIGITAL SCIENCE and TECHNOLOGY RC01 Users Manual

User manual
____RC01
1. Buttons on watch remote control
Buttons on the remote control are shown in the picture below
2. Video button
3. Photo button
4. Button indicator (red)
5. Strap
6. Buckle
1. Power button
1
2. Using the remote control
The watch remote control allo ws you to power on /off the DV a nd to take photos or video at 30M away without operating on DV directly; just press a button to achieve the said functions.
Remark: press any button the two indica tor lamps at both sides will light in red at the same time.
3. Power on/off the DV by remote control
Power on: press and hold the buzzer will beep once.
Power off: press and hold the
4. Changing battery of the remote control
You need to change the battery of the remote control when the battery level is low. Open the
battery cover carefully with a coin and avoid scratching the surface.
To change the battery, put a coin in the slot at the center of the battery cover and unscrew the cover according to the direction marked on it, replace the old battery with the new one (pay attention to the +/-), then cover and screw the cover.
button until the indicator goes off, the DV will turn on and the
button, the DV will turn off and the buzzer will beep once.
2
3
Label Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interferenc e, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
This equipment has been tested and fou nd to comply with the limits for a Class B digital devic e, pursuant to part 15 of the FCC rules. Th ese limits are designe d to provide reason able protection against harmful interference in a residenti al installation. This equi pment gener ates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipm ent off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna .
• Increase the separation between th e equipment and receiver.
• Connect the equipment into an outlet o n a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
4
WARNING
Changes or modifications not expressly a pproved by the party responsible for compliance could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable condition without restriction.
5
Loading...