SHUOYING DIGITAL SCIENCE and TECHNOLOGY PDV1800 User Manual

Panoramic View Camera

PDV1800

1

DDeessccrriippttiioonn ooff aappppeeaarraannccee aanndd kkeeyyss

User’s Manual

2

1. LCD display screen 2.Shutter key

3.Power/Mode 4.Wifi key

5.Busy indicator (red) 6. Charging indicator (blue)

7. WIFI indicator (red) 8. Lens

9. Gear adjusting triangle nut 10. Interface lid (USB, HDMI)

11.Speaker

Use your WIFI camera

1. First insert a micro SD or micro SDHC card, as shown in the right figure:

A high-speed card of Class 6 or above is recommended, and a Class 10 card is needed for video
recording in professional mode.

Be sure to turn off the video camera before a card is inserted or taken out.

3

2. Power on/off

Power on: Press and hold Power key
of the buzzer, the LCD screen will be started (video recording mode is started by default), and the

working indicator in red/Busy indicator will be normally on.
Power saving mode: The device will enter power saving mode when it is in an idle state for one minute
(default setting of the system) without any operation, LCD display will be turned off automatically. And it
can be activated by pressing any key after it is turned off.

Power off: Press and hold Power key
of the buzzer, the LCD screen will be shut down.

The device will be turned off automatically when it is in power saving mo de for 3 minutes (default
setting of the system) without any operation, “Goodbye” will b e displa yed o n the L CD scre en when it is
turned off.

for about 2 seconds and release it, accompanied by a sound

for about 3 seconds and release it, accompanied by a sound

4

3. Charging the camera

An external chargeable lithium battery is used in this device, and its installation is as shown in the figure
below:
Open the cover of the battery:
Mount the battery as per the correct marks
for positive and negative poles;
Then put on the cover of the battery;
In power-off state, connect the device to the USB interface of the computer with a USB cable for
charging. The charging indicator will be in blue in charging. It takes at least 4 hours to complete
charging due to current limit of the USB interface of the computer. After charging is completed, charging
indicator will be off.

5

4. Switch of functional modes

This video camera has three modes: video recording mode, driving mode and photographing mode.

After power is on, modes can be switched by pressing Power/Mode key, or through APP.

Video recording mode: As illustrated below, press Shutter key to start video recording, accompanied

with a sound from the buzzer. In video recording, Busy indicator will be flashing in red all the time,

and LCD timer will start timing. To stop video recording, press this key again.

6

Driving mode: In driving mode, video will be recorded in a cycled way, with a passage of video being

recorded for three minutes by default. When the card is full, the file recorde d earliest will be deleted

automatically so that video recording can continue. As illustrated below, press Shutter key to start

video recording, accompanied with a sound from the buzzer. In video recording, Busy indicator will b e

flashing in red all the time, and LCD timer will start timing. To stop video recording, press this key again.

7