ShowTex AutoReveal User Manual

ShowTex User Manual

AutoReveal

Table of Contents

Introduction 03

Safety Instructions 04

Components 05

Installation 07

1 Open the flight case 07

2 Attach the reveal curtain 07

3 Connect the motor to the connector cable 07

4 Connect the cable to the controller 07

5 Connect the controller to the power cable 08

6 Connect the controller to the power supply 08

7 Assemble the glass fibre rods 08

8 Position the flight case 09

9 Roll out the reveal curtain 09

10 Position the reveal curtain 09

11 Start the reveal 09

Maintenance Instructions 10

Trouble shooting 11

02 ShowTex User Manual AutoReveal

Introduction

The ShowTex AutoReveal is an extremely user friendly reveal system.

· Ideal for unveiling a new car or other types of product launches.

· Reveal products automatically in less than 20 seconds thanks to the easy to use
remote control.

· The Satinac reveal curtain has a standard size of 8 x 5 m and is available in a variety
of colours.

· The Auto Reveal reveal curtain can be made in custom sizes and with printed designs
or logos on request.

· A Velcro attachment strip makes the reveal curtain easy to change and replace.

· The system comes standard with a 220 V single phase motor and a remote control.

ShowTex User Manual AutoReveal 03

Safety Instructions

· Read this user manual carefully

· The AutoReveal system may only be attached to light weight fabrics.

· The maximum load capacity for the motor is 7kg. Overloading the system can cause
damage to it and endanger the system’s users.

· The reveal curtain must unroll and roll up in the correct direction.
The curtain must enter and exit around the roller (not under it) (see step 2)

· Guide the curtain while unrolling it, to prevent the roller from blocking. Remove any
loose objects from the motor casing before activating the system. (see step 8)

· Make sure the reveal cloth is always visible to operator of the system.

· The system must be installed and activated by qualified technicians with knowledge of its
capabilities and limitations. The system must be installed in a dry frost free environment.

· The power supply must be switched off before making any adjustments to the system in
order to prevent electrocution and interference with moving parts.

· The system must always be connected to a suitable grounding cable having at least the
same section as that of the power cable.

04 ShowTex User Manual AutoReveal