ShoreLand'r TA0991 User Manual
ACCESS ORY
TA0991
9” Winch Stand Kit with Mounting Hardware
Assembly Instructions:
Remove winch from frame bundle, reusing bolt
and nut, slide winch into place and insert bolt
through from the handle side of winch through
winch base top hole and secure with the flange
lock nut. Pivot the winch and match the A or B hole
in the winch to the five holes on the winch base,
again insert the ½” x 4 ½” bolt from the winch
handle side through the winch, winch base, and
the bushing securing on the back side with a ½”
flange lock nut. If a jack is going to be mounted to
the winch base it should be done now.
Set the winch assembly on the tongue with the
winch handle side of the winch to the drivers or
street side of the trailer. Insert ½” x 4” carriage
bolts from the opposite side through so that the
square carriage matches the square punched in
the base and out through the other side and secure with ½” flange locknuts. The winch assembly
can be moved forward or back to fit the boat properly. Once proper fit has been obtained tighten all
nuts and insert plastic plugs.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003494
Page 1
Loading...