ShoreLand'r TA0165 User Manual

ACCESSORY

TA0165

Bunk Loadguide for PT1420 - PT1720 Models

ASSEMBLY AND INSTALLATION INSTRUCTIONS
Assembly Instructions
Break the bundles and sort all items. Locate the post load
guide weldments and position one on the rear cross mem­ber.
Orient the weldment as shown in the diagram. Place two
– 3/8” x 2 7/16” x 4” U-bolts up around the cross member
and into the holes provided in the weldment. Secure with

3/8” ange lock nuts. Do not tighten. Repeat this process

with another post load guide weldment on the front cross
member.
Position the carpeted bunk on the outside of the weldments
just installed as shown in the diagram. Attach the bunk to
both the front and rear weldments using the bolts already
installed in the bunks. Secure to the weldments using 3/8”
lock washers and hex nuts.
Repeat the above process on the other load guide on the
other side of the trailer.
Adjustment

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004039

Page 1 01/27/2009

With the pontoon properly centered on the trailer slide the
load guides out until they are within ½” of the inside of the
pontoon tube. Tighten in position. Tighten the bolts attach­ing the bunks to the weldments. This is a good starting
point for adjusting. They may need to be adjusted differ­ently depending on the splash guard on the front of the
pontoon tubes. Unload and reload the pontoon to make

sure they are adjusted to best t your pontoon. They can be
repositioned to best t your need.

Adjustment is complete.

ShoreLand’r offers its product line in painted nishes. When
ordering parts, it is important that you specify the nish or

color you have on your product. The 5-digit number along
with a 2-digit space _ _, note that the parts can be purchased

in various nishes.

00........ Galvanized

03........ Black

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004039

Page 2 01/27/2009