ShoreLand'r TA0155 User Manual

ACCESSORY

TA0155-03

Side Rail Kit for 129” - PS5X10

The TA0155-03 side rail kit is to be used on the side frames of the PS5x10 model trailer. The side rail tubes are designed so that there is no right or left part and no front or rear. They can also be mounted on either the inside or the outside of the side frame. Mounting the side rails on the inside of the frame will be the most eye appealing and is the most desirable position when installing a front shield on a trailer with the side rails.

Assembly Instructions

1. Break the bundle and sort all items by size.

Determine whether the side rails will be mounted on the inside of the frame as shown in Picture A or on the outside as shown in Picture B.

Inside Frame Mount (Picture A)

1. Place a side rail on the trailer so the mounting channel is between the deck planks as shown in Picture A making sure the front of the side rail tube is positioned correctly with respect to the front of the trailer.

2. Place one of the 3/8” x 3 7/16” x 3” square U-bolts around the frame as shown. Insert the legs of the U-bolt through the mating

holes in the channel. Place a 3/8” at washer, lock washer and

hex nut on each leg of the U-bolt. Thread the nuts on until all excess U-bolt length as been threaded through the nut.

3. Repeat step 2 on the rear side rail channel.

4. Tighten the U-bolts securing the side rail to the side frame of the trailer.

5. Repeat the above steps on the remaining side rail.

6. Assembly is complete.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003966

1. Place a side rail on the outside of the trailer side frame so the front of the side rail is positioned correctly with respect to the front of the trailer.

2. Place one of the 3/8” x 3 7/16” x 3” square U-bolts around the side frame between the deck planks as shown in Picture B. Insert the legs of the U-bolt through the mating holes in the chan-

nel. Place a 3/8” at washer, lock washer and hex nut on each

leg of the U-bolt. Thread the nuts on until all excess U-bolt has been threaded through the nut.