ShoreLand'r TA0153-03 User Manual
ACCESSORY
TA0153-03
Sideframe Mounting Spare Tire Bracket
for all Powersports Trailers
The TA0153-03 spare tire bracket has been designed to
specically t on all Powersports trailers. It will attach to
either 2” x 3” or 2” x 4” side frames. It is powder painted in a
black nish only.
NOTE: The spare tire bracket and tire should be mounted on the right side frame (ditch side or away from traf-
c) to reduce potential damage to oncoming trafc in
the event of a tire loss.
The spare tire bracket must be mounted far enough
away from either the front or rear side market lights so
it does not block the 45° photometic lighting angle required by law.
Assembly Instructions
• Open the bundle and sort all items by size.
• Locate the three-1/2” x 1 ½” ne threaded bolts. Insert
them into three of the wheel pattern holes as shown in the
parts drawing.
• Place on a ½” at washer and then secure in place with a
½” lock nut. Tighten.
• Determine the desired location for the spare tire to be
mounted taking into account the forbidden area noted
above.
• The kit is supplied with both size U-bolts so it will mount to
the two size frames mentioned above.
• Slide the correct U-bolt over the side frame as shown. Insert into the mating holes in the spare tire bracket. Secure
with ½” lock washers and hex nuts. Tighten.
• Place the wheel assembly over the studs and secure with
the lug nuts provided. Note that the tapered side of the lug
nut must be towards the wheel so it will t properly into the
wheel lug nut hole. Tighten.
• Assembly is now complete.
CAUTION: Check the spare tire bracket and wheel lug
nuts peridically for tightness to eliminate tire loss during transport.
Refer to page 2 for parts drawing and bill of material.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003961
Page 1
05/05/2008
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003961
Page 2
05/05/2008
Loading...