ShoreLand'r TA0151 User Manual

ACCESSORY

TA0151

ShoreLock’r II Storage Box Mounting Kit

for 3X3 Tongue Applications

The ShoreLock’r II Storage Box (TA0149) must be mounted using the ShoreLock’r II Mounting Kit (TA0151). The

mounting kit ts the following trailer models:

PS4X8•
PS5X10•
PS5X14•
PS6X12•

Single PWC’s w/long tongues •

Improper mounting may void the warranty on the ShoreLock’r II storage box.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003926

04/14/2008

Page 1

Assembly Instructions:

Center the angle supports from side to side inside the storage box.
The angle supports must be ush against the front and rear walls,
too. Using the angle supports, mark the center of the four square
holes on the bottom the storage box. Remove the angle supports.
Using a 7/16” drill bit, drill down through the storage box bottom in
the locations of the four marks just made.

Center the storage box over the 3X3 tongue. Place the angle sup­ports over the holes just drilled. Secure the storage box to the 3X3
tongue using four 3/8” X 4-1/2” carriage bolts through the angle sup­ports. Place the straps under the 3X3 tongue and over the threads
of carriage bolts just installed. Secure with ange lock nuts.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003926

04/14/2008

Page 2