ShoreLand'r TA0011 User Manual
®
TA0011
Fishing Series 8” Roller with Bracket
Picture 1
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003325
Picture 2
TA0011
FISHING SERIES 8” ROLLER WITH BRACKET
The TA0011 8” roller with bracket assembly comes complete with
the mounting hardware to attach it to either a channel cross member as shown in picture No. 1 or a tube cross member as shown in
picture No. 2. It is adjustable up and down by sliding the attaching
bolts through the mounting slot in the bracket. The roller comes
pre-assembled to the bracket. Attach the roller assembly to the
cross member as follows:
Channel Cross Member (See Picture No. 1)
Place one of the ½” pyramidal washers on a ½” x 1 ¼” hex bolt as
shown so the points of the washer are pointing away from the head
of the bolt. Insert the bolt into the slot of the bracket, then into the
hole in the channel cross member of the trailer. Secure with a ½”
lock washer and hex nut. Place a second bolt assembly into the
second slot in the bracket following the above process.
Tube Cross Member (See Picture No. 2)
Place one of the ½” pyramidal washers on a ½” x 3” hex bolt as
shown so the points of the washer are pointing away from the head
of the bolt. Insert the bolt into the slot of the bracket, then into the
hole provided in the tube cross member of the trailer. Secure with a
½” lock washer and hex nut. Place a second bolt assembly into the
second slot in the bracket following the above process.
Adjustment
Position the roller either up or down until the proper height is
achieved. Once positioned, tighten the attaching bolts to secure
the roller in the desired location. Note that the points on the pyramidal washers will bite into the roller bracket to hold it in position
once tightened.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003325
Loading...