ShoreLand'r PT2325AB User Manual
®
PT2325AB
Pontoon Trailer
PT2325AB Pontoon Trailer
69082 Lit Packet - Trailers - Brakes
80615-_ _ Frame Bundle - PT2325AB
*ST185/80D13-D Tire/Rim
69677-_ _ Tongue Assy 90” Pontoon Disc
*Check with your dealer/customer service representative for current tire/rim assembly part number.
ShoreLand’r offers its product line in painted nishes. When
ordering parts, it is important that you specify the nish or
color you have on your product. The 5-digit number along
with a 2-digit space _ _, note that the parts can be purchased
in various nishes.
00........ Galvanized
03........ Black
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003964
Page 1 05/14/2008
Tire Size and Carrying Capacity Chart
Tire Size ............................ST185/80D13-D
GVWR ...............................3420 lb.
Carrying Capacity ............2500 lb.
Axle ...................................Single Axle Brake
Refer to the tire side wall for correct tire pressure.
Diagram A
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003964
Page 2 05/14/2008
BUNKS
(See Detail B in Diagram A, Page 2)
Note that the bunk system is adjustable for width to t most center dimensions of the pontoon tubes. Determine the centers of the
bunk support system that ts the pontoon tubes for the pontoon
that is going to be placed on the trailer and position accordingly.
Position the carpeted bunks so approximately 10” extends past
the back of the rear bunk saddle support. Attach the bunks to the
brackets using the ¼” x 1 ½” lag screws provided. Position the second bunk so it is just to the front of the rear bunk just installed.
Repeat this process on the bunks on the other side of the bunk
saddle support and then on the other side of the trailer.
Remove the small parts from the frame by cutting the banding. Remove the bolt bag and sort all the nuts and bolts by size.
SAFETY CHAINS
Insert a 3/8” x 1 ¼” hex bolt through a 3/8” at washer and then into
the end link of one safety chain. Insert the bolt into the front bottom
hole punched in the tongue. Place another 3/8” at washer on the
bolt and secure with a 3/8” ange lock nut. Tighten.
Repeat this process on the other safety chain.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003964
Page 3 05/14/2008
Loading...