ShoreLand'r PS5X14 User Manual

®

PS5X14

Powersports - 2200 lb. Capacity

Bundles Required - PS5X14

1 65069 Literature Packet - SL Powersports
1 8060203 Frame Bundle -PS5X14
2 *

*Check with your dealer/customer service representative for current tire/rim assembly part number.

ST185/80D13-C Bias Tire/TS Dir Rim

Tongue Weight Adjustment

Approximate Tongue Weight for Best Towing.
NOTE: Axle is adjustable. Shift load to obtain proper tongue

weight. Tongue weight should be 5-7% of total gross weight of the
trailer and load combined.

Tire Size & Carrying Capacity Chart

Tire Load Carrying
Size Range Capacity

ST185/80D13 C 1480 lbs.

Refer to tire side wall for correct tire pressure.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003904

Page 1 REV A 04/15/2008

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003904

Page 2 REV A 04/15/2008

ASSEMBLY INSTRUCTIONS:

SAFETY CHAIN

Refer to Diagram B on page 2 for placement.

Insert a 3/8” X 1-1/4” hex bolt with 3/8” at washer through the

safety chain. Insert this assembly through the lower hole on the

front of the tongue. Secure with a 3/8” at washer and 3/8” ange

lock nut on the inside of the tongue tube. Repeat this procedure on
the other side of the tongue tube.

TONGUE

Refer to parts drawing on page 2 for placement.

Slide the tongue into the tongue channel on the frame assembly

and secure with two 1/2” X 4” hex bolts and 1/2” ange lock nuts.

FRONT STOP

Refer to Diagram A on page 2 for placement.
Mount the front stop weldment to the front of the frame using two
3/8” X 4-7/16” X 3” square u-bolts. The placement of the u-bolts will
go over the front frame tube weldment with the legs of the u-bolt
facing towards the inside of the frame. Secure with 3/8” at wash­ers, 3/8” lock washers and 3/8” hex nuts. Insert black plastic caps
on exposed tube ends.

SPRINGS

Refer to Diagram C on page 2 for placement.

Mount the spring to the axle assembly using two 1/2” X 2-5/16”
X 6-1/2” square u-bolts over the spring clamp and spring. Secure
the spring to the axle assembly using a spring plate and four 1/2”

ange lock nuts. Repeat on opposite side of the axle assembly.

Install the spring bracket bushings and the 9/16” X 3-1/4” hex bolts
into the rear of the spring bracket (already attached to the frame).
Secure with 9/16” hex nuts. Hook the leaf spring on the axle as­sembly over the bushing just installed. Repeat this step on the op­posite side of the axle assembly.

Insert a 9/16” x 3/14” hex bolt in the eye of the leaf spring and se­cure into the front spring bracket. Repeat on opposite side of the
axle assembly.

Tighten all four bolts to secure the under carriage to the trailer.

TIRES

Remove the stud thread protectors. Mount the tires to the hubs
using 1/2” hex lug nuts. Tighten to 85-95 ft./lb. of torque using the
rotation pattern as shown in the ShoreLand’r Owner’s Guide.

Re torque the lug nuts after 50 miles of driving and then periodically
thereafter.

RAMP

Refer to Diagram D on page 2 for placement.

Attach the strap to the welded latch pin on the ramp using a 3/16” X
1-1/4” lynch pin. Repeat on opposite side of the ramp.

Secure the ramp to the rear of the frame weldment using a 9/16”
X 3-1/4” hex bolt and 9/16” hex lock nut. Repeat on opposite side
of the ramp.

Travel Position: Push ramp up and attach the other end of
the strap to the welded latch pin on the side frame using a
3/16” X 1-1/4” lynch pin. Repeat on the opposite side of the
ramp.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003904

Page 3 REV A 04/15/2008

Loading Position: Release 3/16” X 1-1/4” lynch pins from

both sides of the trailer and lay ramp down on a hard surface.
Replace lynch pin back into welded latch pin on the frame so
that it is not misplaced.

CAUTION: Beware of pinch point areas when handling the
ramp!

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003904

Page 4 REV A 04/15/2008

Special Instructions:

Always check lighting and turn signal operations before towing.

Secure or tie-down your load before towing.

Contact your authorized ShoreLand’r dealer if you experi­ence a problem with your trailer. To locate a dealer, please use
www.shorelandr.com - the dealer locator feature.

For more information or assistance, contact ShoreLand’r at 1-800­859-3028 or visit www. shorelandr.com.