Page 1
®
1400U &1400UA
Bundles Required
1400U Utility Trailer w/Ramp & Front Stop
2 *18.5 X 8.5 8-CTire/MSilver Rim
1 65069 Literature Bag - ShoreLand’r Utility
1 6733603 Frame Bundle - 1400U
*Check with your dealer/customer service representative for current tire/rim assembly
part number.
Tongue Weight Adjustment
Approximate Tongue Weights for Best Towing. To achieve
the proper tongue weight, shift the load forwards or move back
on the trailer. The tongue weight should be 5% to 7% of the
total gross weight of the trailer and boat combined.
Caution:
1. To prevent damage to your utility trailer or towing vehicle,
tighten all fasteners before towing.
2. Your utility trailer is equipped with a totally grounded wire
harness. You must be sure the wire harness plug that come
from the tow vehicle is grounded to the tow vehicle using the
white grounding wire.
3. Always secure (tie) your load down before towing.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003190
REV C
1400UA Utility Trailer W/Ramp & Front Stop
2 *ST155/80R13-CTire/MS Dir Rim
1 65069 Literature Bag - ShoreLand’r Utility
1 6743503 Frame Bundle - 1400UA
*Check with your dealer/customer service representative for current tire/rim assembly
part number.
Tire Size & Carrying Capacity Chart
Tire Load Carrying
Size Range Capacity
18.5 X 8.5 X 8 C 940 lbs. per tire
ST155/80R13 C 1100 lbs. per tire
Refer to tire side wall for correct tire pressure.
Tools Required for Assembly
9/16” Wrench / Socket
13/16” Wrench / Socket
7/8” Wrench / Socket
3/4” Wrench / Socket
1/24/06
Page 2
Assembly Instruction
Safety Chain
Insert a 3/8” X 1-1/4” hex bolt with 3/8” flat washer and safety
chain through the lower hole on the front of the tongue. Secure
with a 3/8” flat washer and 3/8” flange lock nut. Repeat this
procedure on the opposite side of the tongue.
Coupler
Mount the coupler to the tongue using two (2) 1/2” X 1” hex
bolts to the front holes and one (1) 1/2” X 4” hex bolt in the
rear hole of coupler. Secure with 1/2” flange lock nuts.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003190
REV C
Axles/Springs
Mount the spring to the axle assembly using two (2) 1/2” X
2-5/16” X 5-3/4” square u-bolts over the spring clamp and
spring. Secure this spring to the axle assembly using a spring
plate and four (4) 1/2” flange lock nuts.
Install the spring bracket bushings and 9/16” X 3-1/4” hex
bolts into the rear frame spring shackle. Secure with 9/16”
hex nuts. Hook the leaf spring on the axle assembly over the
bushing just installed.
1/24/06
Page 3
OPTIONAL ACCESSORIES:
SS1135 1400U BRAKE KIT (12” or 10” TIRE ONLY)
SSBK1136 FRONT STOP KIT
SSBK1137 RAMP KIT
SS1159 3-SIDE RAIL KIT
SS1160 4-SIDE RAIL KIT
SSBK1183 FRONT SHIELD
SSBK1184
SSBK1185 RAMP EXTENSION KIT
MOTORCYCLE FRONT WHEEL CHOCK KIT
SSBK1136
Front Stop Kit
REF# PART# DESCRIPTION QTY
1 6656403 FRONT STOP TUBE WMENT (1400) .........1
2 0140040 HH 3/8-16 X 1 CS GR5 ...............................4
3 1440101 FLANGE LOCKNUT SMALL 3/8-16 ............4
4 3510226 CAP 1 3/4X1 3/4X1 1/2 BLACK ..................2
DECALS:
4811432 SAFETY DECAL - 1400U ........................1
4811433 SHORELAND’R UTILITY DECAL ...........2
4811434 PINCH POINT DECAL ............................2
Insert a 9/16” X 3-1/4” hex bolt in the eye of the leaf spring
and secure into the front frame spring shackle. Tighten all four
(4) bolts to secure the under carriage to the trailer.
Tires
Remove the stud thread protectors. Mount the tires to the
hubs using 1/2” lug nuts.
SSBK1137
Ramp Kit
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003190
REV C
1/24/06
Page 4
SS1159
3-Side Rail Kit
SS1160
4-Side Rail Kit
REF# PART# DESCRIPTION QTY
1 6524003 SIDE RAIL - UTILITY ..................................2
2 6523903 FRONT RAIL - UTILITY ..............................1
3 0110059 3/8” X 3-3/4” HEX BOLT ..............................8
4 1310163 1.377 OD X .390 ID X .105 WASHER .........8
5 0140022 5/16” X 3/4” HEX BOLT ...............................8
6 1310025 S/T MED LOCK WASHER ..........................8
7 1410069 5/16” HEX FINISH NUT ..............................8
8 1310005 3/8” INTERNAL TOOTH LOCK WASHER ..8
9 1410109 3/8” HEX FINISH NUT ................................8
10 6524103 CORNER BRACE - UTILITY .......................2
REF# PART# DESCRIPTION QTY
1 6524003 SIDE RAIL - UTILITY ..................................2
2 6523903 FRONT RAIL - UTILITY ..............................1
3 0110059 3/8” X 3-3/4” HEX BOLT ..............................8
4 1310163 1.377 OD X .390 ID X .105 WASHER .........8
5 0140022 5/16” X 3/4” HEX BOLT ...............................12
6 1310025 S/T MED LOCK WASHER ..........................12
7 1410069 5/16” HEX FINISH NUT ..............................12
8 1310005 3/8” INTERNAL TOOTH LOCK WASHER ..8
9 1410109 3/8” HEX FINISH NUT ................................8
10 6524103 CORNER BRACE - UTILITY .......................2
11 6524303 TAILGATE CHANNEL - UTILITY .................2
12 6524203 UTILITY - TAILGATE ...................................1
13 1540303 5/16” SAFETY SNAP PIN ...........................2
Optional Side Rail
REF# PART# DESCRIPTION QTY
1 -- 52-1/4” X 2 X 4 WOOD ...............................4
2 -- 97-1/4” X 2 X 4 WOOD ...............................4
3 -- 14-1/2” X 2 X 4 WOOD ...............................8
4 -- 1/4” X 1-1/2” HH LAG SCREW ...................8
5 -- 3/8” X 3-1/2” CARRIAGE BOLT ..................8
6 -- 3/8” FLAT WASHER ....................................16
7 -- 3/8” LOCK WASHER ..................................16
8 -- 3/8” HEX NUT .............................................16
For the utility trailer owner’s reference.
This is NOT a kit manufactured by ShoreLand’r.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003190
REV C
1/24/06
Loading...