Shogun Motorsports R1 User Manual

Yamaha R1 2009 No Cut Frame Slider
Installation Instructions
Part Numbers: 750-6739, 755-6739, 750-6730,
850-6730, 710-6739

MADE IN THE USA!
Carefully read instructions in their entirety before the install

Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time. Shogun is not responsible for any part of your motorcycle for any reason. Precisely
measure location of cut and if in doubt at any point please call us before the install process has begun.

Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY Price each Part Numbers Descriptions

1 $20.00 99-FS-750-6739-L Black Left Side Puck
1 $20.00 99-FS-750-6730-L White Left Side Puck
1 $30.00 99-FS-850-6730-L Polished Billet Left Side Puck
1 $60.00 99-OF-750-6730-L Left Side Offset Black Anodized
1 $2.00 99-HB-SH10125060 Socket Cap 10 X 1.25 X 60 (Holds puck to offset)
1 $3.50 99-HB-SH12125090 Socket Cap 12 X 1.25 X 90 Main Engine Stud

Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1 $20.00 99-FS-750-6739-R Black Right Side Puck
1 $20.00 99-FS-750-6730-R White Right Side Puck
1 $30.00 99-FS-850-6730-R Polished Billet Right Side Puck
1 $60.00 99-OF-750-6730-R Right Side Offset Black Anodized
1 $2.00 99-HB-SH10125060 Socket Cap 10 X 1.25 X 60 (Holds puck to offset)
1 $3.50 99-HB-SH12125060 Socket Cap 12 X 1.25 X 60 Main Engine Stud

Frame Sliders: Left frame slider longer than right
Offsets: Left side offset is smaller than right

Installation Steps:

1. Remove left and right body panels. There are several plastic rivets or inner body clips located on
the underside of the mid body panel. To release, press in the center of the body rivet and
remove. On the outside of the body there are several Dzus type fasteners to release shown in
the photo below, once body panel is loose unclip the turn signal connections. This will expose
the main engine stud mounting locations.

2. Remove the left side engine stud. Mount the left side offset using 99-HB-SH12125090 Socket
Cap 12 X 1.25 X 90 Main Engine Stud and torque down to OEM torque specs.

3. Using one drop of blue thread locker mount the left side puck to the offset with 99-HB­SH10125060 Socket Cap 10 X 1.25 X 60 (Holds puck to offset). Torque down to 33 to 35 foot lbs.