Shogun Motorsports CBR1000RR User Manual

HONDA CBR1000RR 08-11
Fender Eliminator Kit

Kit Contents

Part Number Description Quantity Part Number Description Quantity
99-FE-670-3920 Fender Brackets 3 99-Wash6x12 6x12mm Washer 4
99-Wash6x15 6x15mm Washer 4 99-HB-6x12 6x12 Bolt 2
99-LN-6 6mm Locknut 4 99-HB-6x30 6x30 Button Head 2

Carefully read instructions in their entirety before the installing the part.
Professional installation is recommended. Always use proper safety measures during the installation

of this product. Do not try to install this product without proper tools, safety goggles, and gloves. The
motorcycle must be in a fixed, secure position before the installation process begins. DMP is not
responsible for any part of your motorcycle for any reason. Precisely measure location of cut and if in
doubt at any point please call us at [phone] before the installation process has begun

Note: To complete your installation we recommend using DMP Marker Lights and DMP OEM Type
Wire Harness, which are available from your local DMP dealer or www.moto911.com.

1. Remove stock OEM rear fender.

P/N: 670-3920
MADE IN THE USA!

Moto911 Inc. - 1062 CalleNegocio, Ste. J, San Clemente, Ca. 92673 – [phone]

2. MAKE SURE YOU HAVE SAFETY GOGGLES AND GLOVES ON DURING THIS PROCESS!
Once the OEM rear fender has been removed use a cutting wheel to cut around radius of the

protruding posts shown below. We use a small hand saw to finally separate the OEM posts.
NOTE: Be very precise, work slowly, and do not slip, or your stock parts may be altered in a

cosmetically unappealing state.

Moto911 Inc. - 1062 CalleNegocio, Ste. J, San Clemente, Ca. 92673 – [phone]