Shogun Motorsports BMW S1000RR User Manual

BMWS1000RR (12-13) NO CUT Frame Slider
Installation Instructions
Part Numbers: 750-7749, 750-7740, 755-7749,
710-7749

Carefully read instructions in their entirety before the install

Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves.The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time. If in doubt at any point please call us before the install process has begun.

Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY Price each Part Numbers Descriptions

1 $20.00 99-FS-750-7749-L Black Left Side Puck (Longer than right)
1 $20.00 99-FS-750-7740-L White Left Side Puck (Longer than right)
1 $3.50 99-HB-SH10150090 Socket Cap 10 X 1.50 X 90 Main Engine Stud

Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1 $20.00 99-FS-750-7749-R Black Right Side Puck
1 $20.00 99-FS-750-7740-R White Right Side Puck
1 $25.00 99-OF-750-7740-R Right Side Offset Black Anodized
1 $3.00 99-HB-SH10150050 Socket Cap 10 X 1.5 X 50 (Holds puck to offset)
1 $5.00 99-SP-750-7740-R Aluminum Frame Cup Spacer (This spacer is bolted to

the back side of the right side offset using 99-HB-0812530 bolt)
1 $.99 99-HB-0812530 Socket Cap 8 X 1.25 X 30
1 $3.50 99-HB-SH1015060 Socket Cap 10 X 1.50 X 60 Main Engine Stud

Installation Steps: Left side puck longer than right

1. Remove the right lower and mid body panels to expose mounting location.
Tips: If you have a small camera or smart phone take photos of anything you think you may
forget about so you can reference them during the assembly procedure. Note: Be very careful

not to break any bodywork tabs when removing panels.

2. After you have removed the bodywork, remove right side engine stud.

3. Mount right side offset to the motorcycle. Read your service manual for specific torque
specifications associated to those locations. Use (99-HB-SH10150060) 10 X 1.50 X 60 Socket cap
bolt to mount offset to the motorcycle. Leave conical spacers in the frame and torque down
main engine stud. Tip: DO NOT use blue thread locker on the bolt discussed in this section. Start
bolt in by hand make sure you have good thread engagement do not cross thread or over

tighten. Note: Offset shown in this illustration has a raw finish all offsets come black anodized

with a machined finished threaded spacer.

4.

5. Remove left side main engine stud.

6. Mount left side frame slider to the motorcycle. Read your service manual for specific torque
specifications associated to those locations. Use (99-HB-SH10150090) 10 X 1.50 X 90 Socket cap
bolt to mount left side frame sliders to the motorcycle. Leave conical spacers in the frame and
torque down main engine stud. Tip: DO NOT use blue thread locker on the bolt discussed in this
section. Start bolt in by hand make sure you have good thread engagement do not cross thread

or over tighten.