Shogun Motorsports 300R DMP User Manual

Kawasaki Ninja 300R 2013
Fender Eliminator Kit

Kit Contents

Part Number Description Quantity Part Number Description Quantity
99-FE-670-4210 Fender Brackets 2 99-Wash6x12 6x12mm Washer 2
99-Wash6x15 6x15mm Washer 10 99-HB-6x12 6x12 Bolt 2
99-LN-6 6mm Locknut 6 99-HB-6x16 6x16 Bolt 4

Note: To complete your installation we recommend using DMP Marker Lights and DMP OEM Type
Wire Harness, which are available from your local DMP dealer or www.moto911.com. Make sure bike
is turned off during installation. It is highly recommended that the DMP fender Eliminator and marker
lights are installed by a certified technician. DMP is not responsible for any part of your motorcycle for
any reason. If in any doubt please call us during installation.

1. Remove rear seat.

2. Remove the two body work bolts located in front of the tail light

P/N: 670-4210

MADE IN THE USA!

3. Remove side bolts

4. Remove body work rivets

Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673 – [phone]

5. Remove side panel. Bodywork is snapped into place, be careful removing the body work, do
not force. If you are having issues double check to make sure all bolts and rivets have been
removed.

6. Remove the forward seat bolts on the left and right hand side. Remove the seat.

7. Remove tail section Rivets

Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673 – [phone]

8. Remove tail section side bolts and remove tail section. Bodywork is snapped into place, be
careful removing the body work, do not force. If you are having issues double check to make
sure all bolts and rivets have been removed.

9. Remove tail section wiring harness cover and expose the connectors

10. Unclip each connection (It is recommended that you identify each connection and mark them
before being removed)

Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673 – [phone]