Shogun Motorsports 300 User Manual

Ninja 300 NON ABS (13-14) Frame Slider
Installation Instructions
Part Numbers: 710-4129,750-4129, 755-4129,
750-4120, 850-4120

MADE IN THE USA!

Carefully read instructions in their entirety before the install.
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves.The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time without a safe secure support under the engine. Shogun is not responsible for any part

of your motorcycle for any reason. Precisely measure location of cut and if in doubt at any point please

call us before the install process has begun.

Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY Price each Part Numbers Descriptions

1 $20.00 99-FS-750-4129-L Black Left Side Puck
1 $20.00 99-FS-750-4129-L White Left Side Puck
1 $30.00 99-FS-850-4120-L Polished Billet Left Side Puck
1 $60.00 99-OF-750-4120-L Left SideRail Black Powder Coat
1 $4.00 99-HB-SH101500120 Socket Cap 10 X 1.5 X 120 (Holds puck to offset)
2 $.15 99-HW-M10WASH Washer M10 Zinc Plated
2 $.50 99-CP-4120 Finishing Rail Plug Caps

Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1 $20.00 99-FS-750-4129-R Black Right Side Puck
1 $20.00 99-FS-750-4129-R White Right Side Puck
1 $30.00 99-FS-850-4129-R Polished Billet Right Side Puck
1 $60.00 99-OF-750-4120-R Right Side Rail Black Powder Coat
1 $3.50 99-HB-SH10150090 Socket Cap 10 X 1.5 X 90 (Holds puck to offset)
2 $.15 ea 99-HW-M10WASH Washer M10 Zinc Plated
2 $.50 99-CP-4120 Finishing Rail Plug Caps

Replacement Parts List: Front and Rear Engine Studs (as if you were sitting on the bike)
1 $11.00 99-HR-TH3/8-16 x6 11/16-R 9/16 X 160 Welded Threaded Rod Rear
1 $11.00 99-HR-TH3/8-16x9 15/16-F 9/16 X 245 Welded Threaded Rod Front
2 $.50 ea 99-HN-LN3/8-16 9/16 X 18 Pitch Hex Flange Serrated Nut

Frame Sliders: Left Longer than Right

Installation Steps:

1. If you are disassembling your Ninja 300 for the first time it’s always a good idea to have two
separate trays for smaller parts like bolts and clips one for the left and one for the right.

2. Remove small under seat cowls left and right.

3. Remove upper mid panels left and right located under the gas tank.

4. Remove lower body cowls left and right. Note: To remove plastic body clips use a flathead
screwdriver and lightly pop out the center of clip.