
GEL NANO
FITTING INSTRUCTIONS
WARNING!
NOT FOR USE WITH BRACES
DO NOT CHEW YOUR MOUTHGUARD
In order for a mouthguard to protect, fit, and last it must be worn properly
on your teeth and gums as indicated in the fitting instructions. If any
mouthguard is chewed or not worn properly, its protection, fit and
durability will be greatly diminished.
TO FIT THIS MOUTHGUARD YOU WILL NEED:
> Gel Nano Mouthguard > Cold tap water
> Saucepan > Mirror
> Boiling water > A clock or watch with second hand
> Slotted spoon
FITTING INSTRUCTIONS:
1. Fill saucepan with 3 to 4 inches of water. Bring water to a boil.
2. Plug the helmet tether strap into front of mouthguard.
3. Remove water from heat source. Let water stand for 30 seconds, then
place mouthguard in water for 60 seconds. Do not exceed 60 seconds.
4. Carefully remove mouthguard from hot water with a slotted spoon.
Do not remove tether.
5. Cool mouthguard under tap water for 1-2 seconds only to bring surface
temperature to a comfortable level.
6. Lick your lips before placing mouthguard in your mouth.
7. Watching in mirror, line up mouthguard carefully with the centerline of
upper teeth. Fit mouthguard onto and around upper teeth and press
firmly into molars first then front teeth. Do not remove tether.
8. Bring lower jaw forward and up into base of mouthguard with teeth in
alignment with lower channel.
9. Close mouth while biting down hard on mouthguard. Suck in strongly
and use fingers to press edges of mouthguard onto teeth and roof of
mouth through lips and cheeks for 20 seconds.
10. Remove mouthguard and cool under tap water for 30 seconds.
Replace into mouth and test for a good, firm fit.
11. Repeat steps 1 through 10 if fit is not accurate.
12. Tether may now be removed.
©2013 Shock Doctor, Inc.