Shireen 18862PICOAMP Users Manual
Pico Cell Amplifier
User/ Installation Manual
M
odel:Item#18-862
Copyright © 2015 Shireen Inc
All Rights
Reserved
Reproduction, distribution or revision of part or all of contents in this manual in any form
without
written
permission of Shireen Inc is
prohibited.
The information in this guide is subject to change due to function
improvement, design
alteration,
etc. without any prior
notification.
Shireen Inc. 12910 Cloverleaf Center Dr. Suite 110, German town, MD 20874 Tel: 301-838-4380
www.shireeninc.com
Pico Cell Amplifier# 18-862
Shireen Inc. 12910 Cloverleaf Center Dr. Suite 110, Germantown, MD 20874
Tel: 301-838-4380 www.shireeninc.com
2
SAFETY FIRST
For your safety and to prevent injury to the installer or the operator, installation must
be handled by trained professionals only.
Personal safety:
1) This unit is powered by 28V DC power supply. Turn off the electric supply if
you have to do any rewiring or if you are making alterations to wall
sockets.
2) The equipment should only be used with Pico Cell radio devices with RF power
output of less than 1 Watt.
3) The unit is designed for installation on antenna tower or mast, which must only
be done by fully trained personnel.
WARNING.
This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC
Licensee to operate this device. Unauthorized use may result in significant forfeiture penalties,
including penalties in excess of $100,000 for each continuing violation
RF Emissions
Maximum Power Conducted: 40dBm
Minimum distance between antenna and human: 72cm
Pico Cell Amplifier# 18-862
Shireen Inc. 12910 Cloverleaf Center Dr. Suite 110, Germantown, MD 20874
Tel: 301-838-4380 www.shireeninc.com
3
Table of Contents
1. General............................................................................................... 4
2. Preparing to install Pico Cell Amplifier................................................. 4
2.1. Overview ..........................................................................4
2.2. Check for signal strength.................................................4
2.3. Cable Requirements ........................................................4
2.4. Power Requirements .......................................................4
3. Installation……………………………………………...........................................5
3.1. Operating the repeater....................................................5
4. Maintenance and Troubleshooting..................................................... 5
Appendix A
Specifications.......................................................................... 6
Appendix B
Block Diagram ........................................................................ 7
Loading...