Shinybow USA SB-3709M Instruction Manual

MULTIMEDIA AUDIO AND VISUAL
8 S-VHS/Audio Distribution Amplifier
1x8 S-Video(Y/C) / Stereo Audio
INSTRUCTION MANUAL
MODEL : SB-3709M
S-Video/Audio Distribution Amplifi er
S-Video(Y/C) / Stereo Audio Distribution Amplifi er Series
Thank you for purchasing the SB-3709M SVHS S-Video (Y/C) 8 Way Amplifi er. You will fi nd this unit easy to install and highly reliable but it is essential that you read this manual thoroughly before attempting to use this amplifi er.
SAFETY INFORMATION
1.
Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing.
2.
Read all documentation before operating your equipment. Retain all documentation for future reference.
3.
Follow all instructions printed on unit chassis for proper operation.
4.
Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid.
5
Make sure power outlets conform to the power requirements listed on the back of the unit.
6.
Do not use the unit if the electrical power cord is frayed or broken. The power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords and plugs, convenience receptacles, and the point where they exit from the appliance.
7.
Always operate the unit with the AC ground wire connected to the electrical system ground. Precautions should be taken so that the means of grounding of a piece of equipment is not defeated.
8.
Mains voltage must be correct and the same as that printed on the rear of the unit. Damage caused by connection to improper AC voltage is not covered by any warranty.
9.
Power down & disconnect unit from mains voltage before making connections.
10.
Never hold a power switch in the “ON” position.
11.
Do not use the unit near stoves, heat registers, radiators, or other heat Producing devices.
12.
Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an environment which may impede the normal ow of air around the unit, such as a bed, rug, carpet, or completely enclosed rack. If the unit is used in an extremely dusty or smoky environment, the unit should be periodically “blown free” of foreign matter.
13.
Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages. There are no user serviceable parts inside.
14.
Do not drive the inputs with a signal level greater than that required to drive equipment to full output.
15.
Non-use periods. The power cord of equipment should be unplugged from the outlet when left unused for a long period of time.
16.
Service Information Equipment should be serviced by qualifi er service personnel when: A. The power supply cord or the plug has been damaged. B. Objects have fallen, or liquid has been spilled into the equipment. C. The equipment has been exposed to rain D. The equipment does not appear to operate normally, or exhibits a marked change in performance E. The equipment has been dropped, or the enclosure damaged.
IMPORTANT SAFETY INSTRUCTIONS
To insure the best from this product, please read this manual carefully. Keep it in a safe place for future reference. To reduce the risk of electric shock, do not remove the cover from the unit. No user serviceable parts inside. Refer servicing to qualifi ed personnel. To reduce the risk of fi re, do not expose the unit to rain, water or excessive moisture. Do not force switched or external connections. When moving the unit disconnect the serial port connections fi rst then the power cable and fi nally the interconnecting cables to other devices. Do not attempt to clean the unit with chemical solvents or aerosol cleaners, as this may damage the unit. Use a clean dry cloth. Installation of this unit should be in a cool dry place, away from sources of excessive heat, vibration, dust, moisture and cold.
THIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS CONTAINED WITHIN THIS MANUAL
INTRODUCTION
EN 55013 / EN 55020
FCC 47 CFR/Part 15 Subpart B
CONFORMANCE TEST REPORT
FOR
EN 55013 / EN 55020
REPORT NUMBER: ET93S-06-168-1
FOR
FCC 47 CFR/Part 15 Subpart B
Report Number: ET93S-06-168-02
Model Number: SB-3709M
Comment Number : SB-3704, SB-3705, SB-3706, SB-3708, SB-3709, SB-3710,
SB-3714, SB-3716, SB-3730, SB-3733, SB-3737
Input: Video: S-Video (Y/C) Audio: Stereo Audio System (R/L)
Output: Video: 8 x S-Video (Y/C) Audio: 8 x Stereo Audio System (R/L) Power Input: +DC12V, @300mA~500mA
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK),
NO USER SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED SERVICE PERSONAL.
WARNING!
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
This symbol is intended to alert the user to the presence of non-insulated “dangerous voltage” within the products enclosure that may be of suffi cient magnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operational and maintenance (serving) instructions in the literature accompanying the appliance.
To prevent electric shock do not use this (polarized) plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure. To prevent electric shock, match wide blade of plug to wide slot, fully insert.
IMPORTANT NOTE 1:
This amplifi ers output is S-Video (Y/C)/Stereo Audio. If you want Composite Video/Stereo Audio input/output source, Please choose model: SB-3708.
INTRODUCTION
Congratulations on your purchase of one of the most innovative S-VHS/Stereo Audio Signal Distribution products on the market today. The SB-3709M provides 8 composite video and stereo outputs that are identical to the source signal. It is useful for distributing signals from VCRs, Camcorders, Video Game Consoles, DVDs, Satellite Receivers, CATV Set Top Boxes, etc.
Before you make any connections
Make sure all s-video/audio devices to be connected to the s-video/audio amplifi er and are functioning according to their respective operating manuals before connecting them. Always connect the s-video/audio devices to the s-video/audio distribution amplifi er one at a time and make sure each works just as it did before it was connected.
Supplied Accessories
Check that you have the following components in your converter pack; (1) 1 Instruction Manual (2) 1 SB-3709M Distribution Amplifi er (3) 2 Rack Mount Brackets (4) 1 AC Adaptor : 12VDC, @500mA
AC/DC Adaptor Types : CE/UL/SAA/BS
To prevent damage to your television equipment use only the supplied
AC Adaptor and make the power connections to your television
Safety Notice!
3
FEATURES & SPECIFICATIONS
FEATURES
Desktop version only
Allows connection of 8 destination devices
Installs in seconds
SPECIFICATIONS
Input - Video x 1: S-Video (Y/C - Out), 75 Ohms,1Vpp
Input - Audio x 1: Stereo Audio R/L, 1Vpp, 47K Ohms
Output-Video x 8: Y-Out 75 0hms, 1Vpp; C-Out 75 Ohms, 0.4Vpp
Output - Audio x 1: Stereo Audio R/L, 1Vpp, 47K Ohms
• Video Bandwidth: >1GHz
• Video Distrotion: <0.2db (+/- 3db)
• Audio Bandwidth: >20Hz to 60KHz (+/- 0.1db)
• Audio Distrotion: <0.1db
• Channel Isolation: >60db
• S/N Ratio: >60db
• Video Rosstalk: >-60db
• Input Connector: 1 x S-Video and RCA Left & Right audio
• Output Connectors: 8 x sets of S-Video and RCA Left & Right audio
• In/Out Terminal: Color-Coded RCA female connectors
• Power Consumption: 500mA (max.)
• Signal Distance: Up to 1,000 feet
Audio Frequency Response: 20Hz - 20KHz
• Approvals: CE, FCC, RoHS
• Power Supply: 12VDC; 500mA
Size (WxDxH): 5.1 x 3.7 x 1.5 inches (without rack mount)
4
TYPICAL HOOKUP AND OPERATION
SB-3709M
Inputs: S-VHS Input Port Outputs: 8 x S-VHS Output Ports DC Input: 12V @500mA Power SW: on/off
Safeguards and Precautions
A. Keep this unit away from fi re, extremely hot areas, water or moisture of any kind.
B. Do not place this unit on any support that is not fi rm, level and strong.
C. Do not service the unit yourself. Opening the unit’s housing will void the warranty.
D. Servicing must be by Shinybow or by an authorized technician.
C. Illegal duplication of copyrighted material is strictly prohibited by Federal Laws.
1 x 8 S-Video/Stereo Audio Distribution Amplifi er
SVHS System: S-Video (Y/C), Stereo Audio
5
LIMITED WARRANTY
LIMITED WARRANTY
SHINYBOWUSA WARRANTY SHINYBOWUSA Technology warrants this product against defects in materials and workman ship for a period of 3 years from
the date of purchase. Should this product, in SHINYBOWUSA Technology’s opinion, Prove defective within this warranty period, SHINYBOWUSA
Technology, at its option, will repair this product without charge, to whatever extent it shall deem necessary to restore said product to proper operation condition. This does not extend the warranty period.
This warranty does not apply if the fault has been caused by misuse, improper handling care, electrical or mechanical abuse, and abnormal operating condition or non-SHINYBOWUSA Technology authorized modifi cation to the product.
If repairs are necessary under the warranty policy, the original purchaser must return the product to local distributor, freight prepaid.
After repairs are complete, the product will be returned.
REGULATORY COMPLIANCE
The product complies with the relevant standards for CE, FCC and RoHS approval. The power Adaptor/Supply has been tested for compliance with UL.CSA and CE standards.
TROUBLESHOOTING
If you experience a <no signal> with this switcher or distributor outputs, fi rst make certain that the signal being fed to its inputs is acceptable.
Disconnect the cables from the this switcher or distributor inputs and connect them directly to an appropriate monitoring device, if you do not see or hear a signal the problem may well be he signal source itself. Also check that the AC outlet you have used to power the switcher or distributor is actually providing power as a wall switch often controls an AC outlet.
The second most common problem with this switcher or distributor revolves around the cables, Inspect the cables for loose connectors or cable damage such as crushed cable or cables with cuts or nicks. Replace any cable exhibiting these problem.
You also must use the highest quality cables if you want to achieve the best results. Poor quality cables provide will poor quality signals.
6
MULTIMEDIA AUDIO AND VISUAL
1399 Wildfi re Lane | Frisco, TX 75034 1-877-SHINY-USA 1-877-744-6987 1-972-377-2508 sales@shinybowusa.com
www.shinybowusa.com
Loading...