IMPORTANT
Before getting started, read the instructions and save them for future reference.
In some operating systems, the drive software must be installed prior to operation.1.
Do not drop or allow forceful impact to the product, or install it in locations exposed to heavy vibrations, as doing so may severely 2.
damage the product.
Do not disassemble or modify the product in any way. Disassembly or modication may not only void warranty but could cause 3.
damage or lead to le or electric shock.
Do not use or store the product in damp locations or under high temperature. 4.
Liquid entering the product also may cause damage or lead to le or electric shock.5.
TABLE OF CONTENTS
GENERAL INFORMATION 1
PACKAGE CONTENTS 1
PRODUCT FEATURES 1
HARDWARE INSTALLATION 2
PRODUCT SPECIFICATIONS 3
GENERAL INFORMATION
The Shintaro USB 3.0 4-port Internal Hub is ideal for 3.5 inch drive bay installation. It provides an excellent solution for direct access
of USB 3.0 port from front of your computer.
PACKAGE CONTENTS
Shintaro 3.5” USB 3.0 3.5” Internal 4-Port Hub with USB 3.0 Cable•
Screws x 5•
Quick Installation Guide•
Driver CD with Ipad charging software•
PRODUCT FEATURES
Charge your Ipad via our USB 3.0 4-Port Internal Hub•
Compliant with USB 3.0•
Compliant with USB Battery Charging Revision v1.1, which allows fast charging function, portable device can draw up to 1.5A •
from per port from this hub (Ipad not included)
Four USB 3.0 Ports•
USB 3.0 interface is downward compatible with USB 2.0/1.1 interface•
Hot swap and plug and play capability•
Supports SuperSpeed, High Speed, and Full Speed data transfer•
Supports transfer rate up to 5.0Gbps•
HARDWARE INSTALLATION
Remove the 3.5 inch drive bay’s cover at the front of PC 1.
case. (Refer to your computer hardware manual for
instructions on removing the cover).
Place Shintaro USB 3.0 4-port internal hub with cables 2.
into the drive bay.
Connect the Molex Power male connector on the 5.
USB3.0 Internal 4-port hub onto the Molex Power female
connector on he power supply unit of your chassis
Mount the internal 4-port hub rmly on both tracks of the 3.
drive bay using the four screws provided.
Connect the USB 3.0 cable from USB 3.0 Internal 4-port 4.
hub to USB 3.0 port on the computer. Note: If your
computer’s USB 3.0 Port is located outside the chassis,
please remove the bracket first.
Turn on your computer and the USB 3.0 Internal 6.
4-port hub should function properly.
PRODUCT SPECIFICATIONS
Interface to PC
Front Panel I/O
Indicator
Power Input
System
Environments
Certification
System Support
One USB 3.0 Micro-B upstream port(M/B)
Four USB 3.0 Type A downstream ports(PC)
USB 3.0 Port x 4
Power on(Green)/each port
USB Bus Power and extra power from
system power
Operating Temperature: 5°C ~ 40°C
Operating Humidity: 20%RH ~ 80%RH
FCC Class B, CE
Win XP, Win Vista 32/64, Win 7 32/64
Linux Kernel ( USB 2.0 only )
*This specification may be revised without notice.
Loading...