Shindaiwa 488 User Manual
Specifications and Main Features
- Model: Shindaiwa 488
- Engine Type: 2 Stroke, air cooled gas engine
- Engine Displacement: 47.9 cc (2.92 cu in)
- Fuel: Unleaded gasoline oil type only in a ratio of 40:1 mixed with Shindaiwa Premium 2-cycle engine oil
- Carburetor: HDA165 (Diaphragm Walbro)
- Ignition: CDI type (Capacitor discharge ignition)
- Spark Plug: Champion CJ6Y
- Starting: Manual recoil type starter
- Stopping: Toggle switch for grounding
- Power Transmission: centrifugal automatic clutch
- Chain Lubrication: Chain lubrication will be taken care of by an automatic adjustable oiler
- Chain: Chain specifications .325 pitch and .050 gauge
- Chain Oil: Bar and Chain oil Shindaiwa Premium or equivalent type
- Fuel Tank Capacity: 0.60 liters (20.2 oz.)
- Oil Tank Capacity: 0.30 liters (10.1 oz.)
- Handle: Anti-vibration special handle
- Safety Devices: Front guard and rear guard, throttle lock, chain stop, chain brake, and chain catcher are all included
- Weight (without chain and bar): 4.6 kilogram (10.2 pounds )
- Tools Supplied: screwdriver and Spark plug/18 mm socket wrench
Frequently Asked Questions
Q: What is the fuel oil ratio needed for a Shindaiwa 488 chain saw?
A: The recommended fuel oil ratio is 40:1 unleaded gasoline and Shindaiwa Premium 2 cycle engine oil.2
Q: How can i tighten or loosen the chain on my chainsaw?
A: When you wish to adjust the tension of the chain, then you must ensure that the saw is placed on a flat surface. The chain will then be tightened by turning the screw on the chain tensioner clockwise and if the chain needs to be loosened, it will be turned in the opposite direction. Also ensure that the nose of the bar is raised slightly.
Q: Which shindaiwa models use CJ6Y sparkplugs?
A: Shindaiwa 488 is one of the shindaiwa models which allows the use of the CJ6Y spark plugs.
Q: How do you operate a chain saw?
A: Inorder to operate a chain saw, The device needs to be properly powered. So first, check the ignition switch and move it to the ON position, Then fully extend the choke control, then set the throttle to fast idle. Place the saw on the ground and pull the starter cord until the engine turns on.
Q: What to do if the ignition switch is in ON position and the engine still doesn't start?
A: The first step is to open the fuel tank and check if fresh fuel is available. Then look at the spark plug, to see if it is clean, and has the right gap. Lastly check if fuel is successfully reaching the cylinder.
Q: How frequently do I need to carry out maintenance for my chain saw?
A: Regular chain saw maintenance, which includes checking for any fuel or oil spillage, inspecting the air filter, and sharpening the saw chain when required, should be done every day. More detailed maintenance operations should be carried out after every 10 hours and, subsequently, every 40 or 50 hours of use.
User Manual
Loading...