Shindaiwa 357, 72362-93115, 35701 User Manual
3
5
7
0
1
Shindaiwa Inc.
11975 S.W. Herman Rd.
Tualatin, Oregon 97062
Telephone: 503 692-3070
Fax: 503 692-6696
www.shindaiwa.com
Shindaiwa Kogyo Co., Ltd.
6-2-11 Ozuka-Nishi,
Asaminami-Ku, Hiroshima
731-3167, Japan
Telephone: 81-82-849-2220
Fax: 81-82-849-2481
SHINDAIWA OWNER'S/
OPERATOR'S MANUAL
357 CHAIN SAW
WARNING!
Always wear eye
protection when operating this unit.
WARNING!
Minimize the risk of
injury to yourself and
others; read this manual
and familiarize yourself
with its contents!
䊚2003 Shindaiwa, Inc.
Part Number 72362-93115
Revision 9/03
Shindaiwa is a registered trademark
of Shindaiwa, Inc.
Specifications subject to change without
notice.
Part Number 72362-93115 Rev. 9/03
NOTES
2
39
MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL
DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR
ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS
MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED
BY SHINDAIWA KOGYO CO., LTD. THE USE OF PARTS THAT ARE NOT
EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED
PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL
SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A
WARRANTY CLAIM.
If other than the parts authorized by Shindaiwa Kogyo Co., Ltd. are used for
maintenance replacements or for the repair of components affecting emission
control, you should assure yourself that such parts are warranted by their
manufacturer to be equivalent to the parts authorized by Shindaiwa Kogyo Co.,
Ltd. in their performance and durability.
OBTAINING WARRANTY SERVICE
All repairs qualifying under this limited warranty must be performed by a
dealer authorized by Shindaiwa Kogyo Co., Ltd.
If any emission-related part is found defective during the warranty period, it is
your responsibility to present the product to an authorized Shindaiwa dealer.
Bring your sales receipts showing the date of purchase for this engine. The
dealer authorized by Shindaiwa Kogyo Co., Ltd. will perform the necessary
repairs or adjustments within a reasonable amount of time and furnish you with a
copy of the repair order. All parts and accessories replaced under this warranty
become the property of Shindaiwa Kogyo Co., Ltd.
To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa
Distributor. For the name and telephone number of the Shindaiwa Distributor in
your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00
AM and 5:00 PM Pacific Standard Time.
Introduction
The Shindaiwa 357 Top-Handle saw
has been designed and built to deliver
superior performance and reliability
without compromise to quality,
comfort, safety, or durability.
Shindaiwa high performance
engines represent the leading edge of
2-cycle engine technology, and deliver
exceptionally high power at remarkably low displacement and weight. As
a professional owner/operator, you'll
soon discover why Shindaiwa is simply
in a class by itself.
IMPORTANT!
The information contained in this
manual describes machines available
at the time of production. While every
attempt has been made to give you
the very latest information about your
Shindaiwa 357 chain saw, there may
be some differences between your
saw and what is described here.
Shindaiwa Inc. reserves the right to
make changes in production without
prior notice, and without obligation to
make alterations to machines previously manufactured.
WARNING!
Contents
Page
Attention Statements........................... 4
Product Description ............................5
Specifications ....................................... 6
Safety Information ...............................7
Installing the Bar and Chain ............. 11
Adjusting the Saw Chain ................... 13
Mixing Fuel ......................................... 14
Filling the Fuel Tank/Bar Oil ........... 15
Starting the Saw .................................. 16
Carburetor Adjustments .................... 19
Chain Brake ........................................ 21
Cutting with the Saw .......................... 23
Routine Maintenance .........................27
Long-term Storage ............................. 29
The Saw Chain .................................... 30
Troubleshooting ................................. 33
Emission System Warranty ............... 36
DESCRIPTION
THIS WARRANTY IS ADMINISTERED BY
Shindaiwa Inc.
11975 S.W. Herman Rd.
Tualatin OR. 97062
(503) 692-3070
38
The engine exhaust from this
product contains chemicals known
to the State of California to cause
cancer, birth defects or orther
reproductive harm.
This symbol on the nameplate
means this saw is listed by the
Underwriters Laboratory, Inc.
CN
3
Attention Statements
DESCRIPTION
Throughout this manual are special
“attention statments”.
WARNING!
A statement preceded by the
word “WARNING” contains
information that should be
acted upon to prevent serious
bodily injury.
CAUTION!
A statement preceded by the
word “CAUTION” contains
information that should be
acted upon to prevent
damaging your saw.
IMPORTANT!
A statement preceded by the word
“IMPORTANT” is one that possesses
special significance.
NOTE:
A statement preceded by the word
“NOTE” contains information that is
handy to know and may make your job
easier.
Read and follow the Operator’s
Manual. Failure to do so could
result in serious injury.
Wear eye and hearing
protection at all times during
the operation of this unit.
Do not operate this tool if you
are tired, ill or under the
influence of alcohol, drugs,
or medication.
Beware of Kickback!
Kickback can occur whenever
the tip of the guide bar touches
an object while the saw is
operating. Kickback may force
the bar up and back toward
the operator with a lightningfast reaction!
Pinching the saw along the
top of the guide bar may force
the bar rapidly back toward
the operator. Pinching can
occur whenever wood closes
in around the moving chain.
All chain saw service, other than the
items listed in the owner's manual
maintenance instructions, should be
performed by trained Shindaiwa
chainsaw service personnel. (For
example, if improper tools are used to
remove the flywheel or if an improper
tools is used to hold the flywheel in
order to remove the clutch, structural
damage to the flywheel could occur
and could subsequently cause the
flywheel to burst).
PARTS COVERED
Listed below are the parts covered by the Federal Emission Design and Defect
Warranty. Some parts listed below may require scheduled maintenance and are
warranted up to the first scheduled replacement of that part. The warranted parts
include:
1. Carburetor Internal Components
• Valve Assembly-throttle, Jet, Metering Diaphram
2. Ignition System Components
• Ignition Coil
• Flywheel Rotor
The emission control system for your particular Shindaiwa engine may also
include certain related hoses and connectors.
LIMITATIONS
The Federal Emission Design and Defect Warranty shall not cover any of the
following:
(a) conditions resulting from tampering, misuse, improper adjustment
(unless they were made by the dealer or service center authorized by
Shindaiwa Kogyo Co., Ltd. during a warranty repair), alteration,
accident, failure to use the recommended fuel and oil, or not perform-
ing required maintenance services,
(b) the replacement parts used for required maintenance services,
(c) consequential parts used for required maintenance services,
(d) diagnosis and inspection fees that do not result in eligible warranty
service being performed, and
(e) any non-authorized replacement part, or malfunction of authorized
parts due to use of non-authorized parts.
MAINTENANCE AND REPAIR REQUIREMENTS
You are responsible for the proper use and maintenance of the engine. You
should keep all receipts and maintenance records covering the performance of
regular maintenance in the event questions arise. These receipts and
maintenance records should be transferred to each subsequent owner of the
engine. Shindaiwa Kogyo Co., Ltd. reserves the right to deny warranty coverage
if the owner has not properly maintained the engine. Shindaiwa Kogyo Co., Ltd.
will not deny warranty repairs, however, solely because of the lack of repair,
maintenance or failure to keep maintenance records.
4
37
The following statement only applies to United States and its territories
Shindaiwa Kogyo Co., Ltd.
Federal Emission Design And Defect Limited Warranty
Utility And Lawn And Garden Engines
Shindaiwa Kogyo Co., Ltd. warrants to the initial purchaser and each
subsequent owner, that this utility equipment engine (herein engine) is
designed, built and equipped to conform at the time of initial sale, to all
applicable regulations of the U.S. Environmental Protection Agency (EPA),
and that the engine is free of defects in materials and workmanship that would
cause this engine to fail to conform with EPA regulations during its warranty
period. This emission warranty is applicable in all States, except the State of
California.
For parts listed under PARTS COVERED, the dealer authorized by
Shindaiwa Kogyo Co., Ltd. will, at no cost to you, make the necessary
diagnosis, repair, or replacement of any defective emission-related component
to ensure that the engine complies with applicable U.S. EPA regulations.
Product Description
Brake Lever/Hand
Guide Bar
Saw Chain
Fuel Filler Cap
Guard
Throttle
Lockout Lever
Front Handle
3
5
7
0
1
Starter
Handle
DESCRIPTION
Rear Handle
Oil Filler
Cap
MANUFACTURERS WARRANTY COVERAGE
When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered
to the original retail purchaser.
OWNER’S WARRANTY RESPONSIBILITIES
As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Kogyo Co., Ltd.
recommends that you retain all receipts covering maintenance on your engine,
but Shindaiwa Kogyo Co., Ltd. cannot deny a warranty claim solely for the lack
of receipts or for your failure to ensure the performance of all scheduled
maintenance.
As the engine owner, you should however be aware that Shindaiwa Kogyo
Co., Ltd. may deny your warranty coverage if your engine or a part has failed
due to abuse, neglect, improper maintenance or unapproved modifications.
You are responsible for presenting your engine to the nearest dealer
authorized by Shindaiwa Kogyo Co., Ltd. when a problem exists.
If your Shindaiwa Dealer is unable to answer questions regarding your
warranty rights and responsibilities, you should then contact your Shindaiwa
Distributor.
For the name and telephone number of the Shindaiwa Distributor in your
area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00
AM and 5:00 PM Pacific Standard Time.
35702
Muffler
Outlet
Clutch
Cover
IMPORTANT!
The operational procedures described in this manual are intended to
help you get the most from your
machine and also to protect you and
others from harm. These procedures
are general guidelines only, and are
not intended to replace any safety
rules/laws that may be in force in
your area.
Throttle
Lockout Lever
Throttle Lockout
Button
35723
Ignition SwitchThrottle Trigger
If you have any questions regarding
your 357 chainsaw, or if you do not
understand something in this manual,
your Shindaiwa dealer will be glad to
assist you.
36
5
Specifications
DESCRIPTION
Model ....................................................................................................................... 357
Engine Type ................................................................ 2 cycle air cooled gas engine
Displacement .............................................................................. 35.5 cc (2.17 cu.in.)
Fuel ..................... Gasoline-Oil Mixture—50:1 with Shindaiwa 2-cycle Mixing Oil
Carburetor ......................................................... Diaphragm (WALBRO Model WT)
Ignition ...................................................... All transistor electronic ignition system
Spark Plug .......................................................................................... Champion CJ6Y
................................................................. For EMC compliance use NGK BPMR7A
Starting ...................................................................................................... Auto-rewind
Stopping ............................................................................ Grounding (toggle switch)
Power transmission ...................................................... Automatic centrifugal clutch
Chain lubrication ........................................................ Automatic clutch-driven oiler
Chain ..................................................................................... 3/8" pitch, gauge 0.050"
Chain oil ................ Shindaiwa brand premium Bar and Chain Oil (or equivalent)
Fuel tank capacity ............................................................................... 265 ml (9.0 oz)
Oil tank capacity .................................................................................. 210 ml (7.1 oz)
Front/Rear Handles .............................................. Special anti-vibration mountings
Cooling system ........................................................................................... Forced air
Safety devices .......... Front guard, throttle lock, chain catcher and inertial brake
Weight (less bar and chain) ............................................................... 4.2 kg (9.3 lbs)
Tools Included
■ Screwdriver
■ Spark plug/13 mm socket wrench
■ 4 mm hex wrench
■ 5 mm hex wrench
Do not make unauthorized modifications to this saw, guide bar, or
chain!
WARNING!
RECOMMENDED BAR AND CHAIN COMBINATIONS
Part Number
Size Chain Bar
12-inch Oregon威 91 VG-45X 36120-12
14-inch Oregon威 91 VG-53X 36349-14
16-inch Oregon威 91 VG-57X 36450-16
this saw must meet applicable
ANSI B175.1-2000 kickback
performance requirements,
and/or be designated as “low
kickback chain” per ANSI
B175.1-2000 standards.
WARNING!
Replacement chain for
Troubleshooting
ADDITIONAL PROBLEMS
Symptom Possible Cause
Poor
acceleration.
Engine stops
abruptly.
Engine difficult
to shut off.
Chain rotates
at idle speed.
Excessive
vibration.
Clogged air cleaner.
Clogged fuel filter.
Chain brake engaged
Carburetor mixture
too rich or too lean.
Idle speed set too low.
Spark arrester clogged
Switch turned off.
Fuel tank empty.
Clogged fuel filter.
Water in the fuel.
Shorted spark plug or
loose terminal.
Ignition failure.
Piston seizure.
Ground (stop) wire is
disconnected, or switch
is defective.
Overheating due to
incorrect spark plug.
Overheated engine.
Engine idle too high.
Broken clutch spring
or shoe.
Worn or damaged
sprocket, chain or bar.
Bent crankshaft.
Remedy
Clean the air cleaner element.
Replace the fuel filter.
Inspect and/or test brake.
Consult with an authorized
servicing dealer.
Adjust carburetor.
-1
Adjust: 2,600-3,000 RPM (min
Clean spark arrester.
(See page 29).
Set the switch to “I” (ON), re-start.
Refuel.
Clean or replace filter as required.
Drain; replace with clean fuel.
Clean and replace spark plug.
Tighten the terminal.
Consult with an authorized
servicing dealer.
Consult with an authorized
servicing dealer.
Test and replace as required.
Correct plug:
Champion CJ6Y. For EMC
compliance use NGK BPMR 7A
Idle engine until cool.
Set idle: 2,600-3,000 RPM (min-1).
Replace spring/shoes as
required.
Inspect and replace chain
components as required.
Consult with an authorized
servicing dealer.
)
TROUBLESHOOTING
6
35
Loading...