Shinano Kenshi PTX1 Safety Instructions

PTX1 Safety Instruction

R

IMPORTANT

FCC NOTICE

This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.

F exposure information:

To maintain compliance with FCC RF exposure requirements, please use the product that maintain a
20cm separation distance between the user's body and the antenna of product.
MPE limit for RF exposure at prediction frequency is 1.0 mW/cm2 for this product. The MPE for 2.4GHz
is 0.068 mW/cm2. It satisfy RF exposure compliance.

CAUTION

･

Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
The laser beam emitted from the optical pickup is invisible. Accordingly:

Do not open the optical pickup housing.

LASER INFORMATION

This product has been designed and manufactured according to IEC 60825-1 on
the Safety of laser products.
This Laser product comes under "Class 1 Laser Product".

IC NOTICE

This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

