Gear sensor
SE-G2
Operation manual
Thank you for purchasing the gear sensor. Please read through the
manual to use the product safely.
Model SE-G2 is a solid proximity switch especially designed
for gearing sensing. The SE-G2 sensor will provide a square
wave signal output and indicate detection via LED indicator on
the rear of the unit.
■Specication
Model
Power supply
Power consumption
Response frequency
Actuator
Output impedance
Out put capacity DC5～20V Max.25mA
Target lamp Yes
Operation temperature
Protection IP-67
Cable 3Wires 1M
SE-G2
DC+8.5～+16V DC
Less than 10mA
0～8000Hz
Module 1.0 to 1.5
Magnetic metal
gearing whose tooth
width is over 4mm
Voltage output
-20～+70
98421A
℃
■Installation
Mark groove
Gearing
Clearance
Mark groove
1.Install the sensor and the actuator on the same line.
2.Aligne the grooves to the tooth of the gear.
3.Please set the clearance less than 1mm between the sensor
and the gear tooth.
4.Please keep any other metal material at least 15mm away
from the sensor.
5.When the output is Low, the target lamp is less bright, and
when it is High, it is brighter.
■Output diagram
3.6kΩ
■Dimension
M16 P=1.0
Washer
Used RPM : 0 to 8000rpm
No of teeth : 60 pcs, in case of Module 1.0
VCC (Brown) Power (+)
Output (Black) signal
0V (Blue) (-)
55.0
50.0
Nut(2)
(1000)
LED
φ4.7Cable
(mm)
6.It detects the tooth of the gear.
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...