Shimpo Instruments DT-5RL-1, DT-5RL-2, DT-5RL-3 Data Sheet
Panel Mount
Tachometer
Model DT-5RL-1, 2, 3
*
Features
• Range (0 - 99999)
•
Accuracy 0.01% F.S.
Input frequency 5KHz max.
•
•
Measures RPM or linear speed (scaleable)
Instruction Manual
Name of Parts
To access keys, remove front bezel with flathead screwdriver
in slot at bottom of bezel and twist.
•
Linear Speed y/min, m/min or ft/min (selectable)
Number of ppr (1 - 9999)
•
•
Decimal point selectable
•
Display 5 digit LED .56" (14.22mm) high
Sampling Time 0.1 ~ 99.9 sec. (selectable)
•
Wiring Detail
DIGITAL TACHOMETER
DT-5RL-
NIDEC-SHIMPO
AMERICA CORPORATION
ITASCA, IL (630) 924-7138
1 2 3 4 5 6 7 8
SIG OV
S/N
No. SIGNAL INPUT
1 TTL LEVEL
2 NPN O.C.
3 1-60VAC
+12V
50mA
230 VAC
115 VAC
Symbol Detail
•
"dP" (decimal point selection)
•
"diS-t" (display "function" selection)
•
"r-t" (RPM)
"L-t" (linear-speed)
•
•
"unit" (display unit)
"nn" (M/min)
•
"Ft" (Ft/min)
•
•
"Y" (Y/min)
•
"PPr" number of pulses per revolution
•
"LS-t" sampling time (0.1 ~ 99.9 seconds)
•
"Aug" select according to how fast the observed
speed changes. Set anywhere between 1and 99.
Set diameter of feeding roller through the three
rotary switches.
OperationOperation
Operation
OperationOperation
Turn Power-ON
Display
Push
dp — Press increment key
Push
diS-t — Press increment key
Push
Unit — Press shift
Push
PPr — Press shift key
Push
LS-t — Press shift key
key — Press shift and increment keys simultaneously for at least 3 sec.
Now the decimal point can be selected.
key — Press key. Now you can select RPM or linear speed.
key — If "L-t" is selected. Now "units" can be chosen.
and increment keys and select "M/min", "Ft/min" or "Y/min".
key — Now you are in the PPr field.
and increment key and select the number of PPr anywhere from 1 to 9999.
key — You are in the minimum RPM/Linear rate field. (minimum speed)
and increment key and select cut-off sampling time
anywhere from 0.1 to 99.9 sec. Factory setting is 3 sec.
and set the decimal point.
and select "r-t" or "L-t".
Push
Aug — Press shift key
Push
Input Connection DiagramInput Connection Diagram
Input Connection Diagram
Input Connection DiagramInput Connection Diagram
key — You are now in the speed stability field.
depending how fast speed changes.
key — Press shift and increment keys (simultaneously) momentarily and start measuring
or push
key and start cycle all over again.
and increment key and set value between 1 and 99
SHIMPO IN STRUMENTSSHIMPO IN STRUMENTS
SHIMPO IN STRUMENTS
SHIMPO IN STRUMENTSSHIMPO IN STRUMENTS
Loading...