SHIMPO FGS-1000H User Manual

FGS-1000H
Manual Turn-Wheel Force Test Stand

SHIMPO’s manual test stands offer the ability to obtain accu­rate, consistent results without the high cost of a motorized sys­tem. Our turn-wheel test stand is excellent for applications where
more precise control is necessary.

The FGS-1000H turn-wheel test stand has a 1000 lb. (500 kg) ca­pacity and can ensure accurate, consistent test results with the
addition of a SHIMPO Instruments digital or mechanical force
gauge.

Nearly all manufacturers’ gauges are compatible with SHIMPO’s
test stands for incredible versatility. These stands are designed
for precision, balance, and durability. Therefore they are perfectly
suited for measuring a limitless range of materials such as, wire,
spring, plastic, paper cord, tubing, glass and composites.

Top Plate Adjustment:

Loosen the 1/4” cap screws that secure the top plate in position.
While supporting the upper plate, pull the quick release pins. Low­er the platform to give the desired height from the lower platform
to the gauge end, leaving room for your accessories and mate­rial. Replace the quick release pins and tighten the cap screws to
secure the platform.

SHIMPO INSTRUMENTS

The Hand Wheel:

ø6.8”
The hand grip section is rounded with a thickness of 1”. A 1.25”
wrench flat is located at the top of the hand wheel assembly to
allow for an easy assist on adjustments at high loads.

General Use:

Set the top plate at the length needed for your task. Mount the
gauge by inserting the cap screws from the back side of the gauge
mounting plate into the back of the gauge. Mount the accessories
needed to accomplish your test. Adjust the base plate to center
you load directly under your gaugecenter. Begin testing.

Caution:

Wear safety glasses. Springs or other materials tested can contain
substantial potential energy. Parts can break apart, fracture, or
collapse if subjected to forces beyond their structural integrity.

SPECIFICATIONS

Capacity: 500Kg (1,000lbs.)
Adjustable Range: up to 13”
Sample Platform: 6” diameter
Full Length Stroke: 6” stroke
Hand Wheel Travel Speed: 0.1” per revolution

INCLUDED PARTS

5mm Allen wrench……………………………….........................1pc.

3/16” Allen wrench……………………………..…......................1pc.

1/4” Allen wrench………………………………..........................1pc.

Phillips head screw M4x15…………………............................4pcs.

Allen head screw M6x14………………………........................4pcs.

10 mm Threaded Stud……………………………..…................1pc.