SHIMPO DT-311J-230V User Manual

Model DT-311J

And

DT-311J-230V(AC)

DIGITAL STROBOSCOPE

INSTRUCTION MANUAL

1. GENERAL

The DT-311J DIGITAL STROBOSCOPE is designed to assist mechanical
timing adjustments and emit flashes synchronously with an external
signal and an internal signal. Flashes can be delayed continuously from 0
up to 359 degrees at a positive edge of an external signal by regulating
the adjustment knob and the delayed angle is shown on the LED display.
Zero position can be set to any optimal synchronous position. Revolutions
per minute (RPM) can also be displayed.

IMPORTANT SAFETY INSTRUCTIONS

Do not apply a strong shock or rapid temperature change to the unit.
Especially, do not leave it where temperature will rise: for instance, in a
closed automobile, exposed to direct sunlight, near a stove, open flame, etc.
This instrument is protected against water drips. Do not spray or immerse in
water. Do not open and disassemble the unit. Make sure of proper voltage!

(1) Do not use stroboscope in an explosive atmosphere as it generates
high electrical energy pulses.
(2) To avoid potential eye damage, do not look directly at flashes.
(3) Before operation, make sure there is no damage on the provided AC
voltage line cable. If the cable is damaged, replace it with a new one.
(4) To protect against water drips, carefully thread the power cable
connector firmly to the stroboscope. After metal connector of the
cable has been properly fitted onto the body, the power cable can
then be safely plugged into a properly grounded AC receptacle.

2. SPECIFICATIONS

(1) Flashing range 200 – 1,500 rpm

(2) Phase shift 0 – 359º
(3) Internal signal range 200 up to 1,500 rpm
(4) Delay setter ROTARY ENCODER
(5) Display 4 digits, 10mm high, Red LED
(6) Divided ratio 1/1, 1/2, 1/3, 1/4, 2/4 with shift
(7) Input signal High level, 5 to 24v pulse width,

2 msec min.
Low level, 0 to 1v pulse width,
2 msec min.
1p/r.
Output impedance less than 10k
ohms

(8) Input impedance 47k ohms

(9) Display mode phase shift (degree), Tachometer
(10) Accuracy +/- 1 digit
(11) Flash tube Xenon lamp: Max 10W at 1,500 rpm

Life: 100 million flashes
(12) Operating temperature 32º - 104º F (0 - 40º C)
(13) Power requirement 110 VAC, (230VAC model) +/-10% at

50/60 Hz
(14) Power consumption 20 VA MAX
(15) Dimensions 8.43”L x 5.87”W x 6.85”H

(214 mm x 149 mm x 174 mm)
(16) Weight 4.19 lb (1.9kg)
(17) Accessories included 6m (19’) cable with connector, 1 pc.

Instruction manual, warranty card

3. DIAGRAM

A. Front panel

(1) Xenon lamp
(2) Protective window
(3) Protective window screws
(4) Reflector

(5) Handle

B. Rear (Display & Operation panel)

(1) Delayed angle or rpm display
(2) Mode indicators