Shimpo DT-2100-OP-CAS-L Instruction Manual

Low Speed Contact Adapter

(For DT-2100 only)

DT-2100-OP-CAS-L

Setting

　②

Select in the DT-2100 main body display SET_CONTENTS menu

3. SET_SYSTEM → 5. CONTACT → 4. Contact(Low)

(For additional setting procedures, please refer to the operation

manual for DT-2100)

Instruction Manual

Safety Requirements

Before operation, maintenance and inspection, please carefully
read this instruction manual/DT-2100 manual and follow it for proper
use. Start using only after you have read about the equipment’s
functions, safety information and precautions.

Regarding this product

■

This product is the contact adapter for low speed measurement, built

specically for the hand-held non-contact multi-functional digital tachometer
"DT-2100" (sold separately).
Using this product, low speed rotations, as low as 0.10 rpm, can be measured.

1. Preparations

Before using the low speed contact adapter, please perform the
following preparatory steps.

Installation

　①

Attach the contact adapter to DT-2100 main body as illustrated below.

Operation key 2

Select 5. CONTACT Select 4. Contact(Low)

*

This contact adapter works with 4. Contact (Low) setting. 3. Auto setting
cannot be used.

Select 3. SET_SYSTEM

2. Measurement

Please perform the measurement in the same manner as standard

contact adapters.

For the measurement method and precautions, please refer to
the operation manual of the DT-2100.

3. Specications

Item Description

Measurement range

Measurement

accuracy

Housing Polycarbonate resin (Black Paint)

Weight 50g (Contact Adapter only)

Accessories

*・Additional errors in the measurement accuracy may be caused by the

measuring environment.
(hand stability, the angle to the target, etc.)

・In the case of contact measurements, the slippage of the contact or the

measurement wheel may result in additional inaccuracies.
* Note that applying solvents such as thinner or alcohol, etc. to the contact
adapter may result in the paint peeling and/or damage to the contact adapter.

Cleaned only with a clean damp cloth with water or mild detergent and water.

0.10 rpm ～ 10.00 rpm

0.10 rpm ～

1.01 rpm ～ 6.00 rpm : ±0.60 rpm

6.01 rpm ～ 10.00 rpm : ±1.00 rpm

2 cone adapters
1 funnel adapter

Master wheel (6”Cir.)
Extension shaft

1.00 rpm : ±0.06 rpm

Contact Adapter (Low)

DT-2100

1701 Glenlake Avenue Itasca,IL60143 USA
Phone:[phone] FAX:[phone]