Page 1
TL-BME01
Installing the battery mount SM-BME61
SI-BME0A-000
Attach the mount lower case (E)
to the mounting holes in the
frame, insert the mount fixing
bolts (C) into the washers (D),
and secure the case using the
bolts.
Then, temporarily attach the key
1
unit (B) with the key unit fixing
bolts (A) .
Use the TL-BME01 (G) to position
the key unit. Fit the two bosses
(F) of the key unit into the holes
in the TL-BME01. Adjust the
position of the key unit so that
the contact surface (H) of the
TL-BME01 will be pushed against
the mount lower case as shown
2
in the illustration. Then, fully
tighten the key unit fixing bolt.
Finally, remove the jig and attach
the key unit cover. Make sure
that the battery can be smoothly
connected and disconnected and
no noise will be produced due to
looseness during traveling.
(B)
(A)
(F) (G)
(H)
(E)
(D)
(C)
(A) Key unit fixing bolt (M5)
(B) Key unit
(C) Mount fixing bolt (M5)
(D) Washer
(E) Mount lower case
Tightening torque:
3 N·m
{27 in. lbs.}
(F) Boss
(G) TL-BME01
(H) Contact surface
Tightening torque:
3 N·m
{27 in. lbs.}
Fully tighten the key unit fixing
bolts (M) to attach the key unit
cover (L).
Insert the plug (I) into the mount
lower case. Insert the plug
between the mount upper case
(J) , and secure them using the
mount upper case fixing bolts (K).
3
Please note: specifications are subject to change for improvement without notice. (English) © Jul. 2014 by Shimano Inc. HTR
(L)
(K)
(J)
(I)
(M)
(I) Plug
(J) Mount upper case
(K) Mount upper case fixing bolt
(M3)
(L) Key unit cover
(M) Key unit cover fixing bolt
(M4)
Tightening torque:
0.6 N·m
{5.3 in. lbs.}
Loading...