SHIMANO SWAN1 User Manual

SWAN-1

8 May 2012 Rev.E

SHIMANO INC. Confidential

Wireless Module

SWAN-1

User’s Manual

SHIMANO INC. 1/11

SWAN-1

TABLE OF CONTENTS

Introduction ................................................3

General description ...................................3

Block diagram ............................................3

Software install...........................................4

Operating procedure..................................4 - 6

8 May 2012 Rev.E

SHIMANO INC. Confidential

Regulatory information..............................7 - 11

Rev. Record

07 Mar. 2012> Rev A
03 Apr. 2012> Rev B
23 Apr. 2012> Rev C
26 Apr. 2012> Rev D
08 May 2012> Rev E

SHIMANO INC. 2/11

8 May 2012 Rev.E

SWAN-1

SHIMANO INC. Confidential

Introduction

This document describes the system operation of SWAN-1 –ANT module, as well as driver installation and
the use of control software.

General description

SWAN-1 is an ANT module which has UART interface. This module can support a range of +1.9V ~ +3.6V
power supply and regulated in main chip, nRF24AP2. A reference clock is used in the device, which is of
16MHz.

Block diagram

SHIMANO INC. 3/11

SWAN-1

Software install

1. USB Driver
Connect EVB and PC by USB cable.
Run USBXpressInstaller.exe in “USB Board Drivers” folder

2. ANTware

Run ANTwareII_v3.0.11.msi.

Operating procedure

1. Continuous transmission

a. Connect EVB and PC by USB cable. Run ANTware. Click and open right window.
b. Click “General” tab and uncheck “Increment last byte every message”.

8 May 2012 Rev.E

SHIMANO INC. Confidential

c. Click “Broadcast” tab. Type in “1ba84b3e1ba84b3e” and click “Set Broadcast”.
d. Set frequency and click “Set Radio Frequency”.
e. Type in “256” instead of 8192 and click “Set Channel Period”
f. Click “Auto-Open”

SHIMANO INC. 4/11