SHI KISB Electronic BTK 729 User Manual

Bluetooth® headset

users Manual

BTK-729

STOP

AND

READ

BEFORE YOU BEGIN TO USE YOUR JUST WIRELESS®

BLUETOOTH® HEADSET, YOU MUST FULLY CHARGE AND PAIR

IT WITH YOUR MOBILE PHONE. PLEASE READ THE ENCLOSED

USERS MANUAL FOR EASY PAIRING INSTRUCTIONS.

SHOULD YOU NEED ASSISTANCE, PLEASE CALL 888-753-6957.

INTRODUCTION

Thank you for purchasing the Just Wireless Bluetooth® Headset. We hope you enjoy it. This manual
will get you started and help you to get familiar with the features of your headset. For those individuals
with the Bluetooth® Headset, in addition to all the other features, the unit supports a multipoint func­tion to allow simultaneous connection of the Bluetooth® Headset with 2 mobile phones.

About your Just Wireless bluetooth heAdset

Your Just Wireless® Bluetooth® Headset lets you do the following functions, provided your mobile
phone can support it:

•

Making a call

•

Ending a call

•

Answering calls

•

Adjusting Volume

•

Voice Command Dialing

•

Redialing last number

•

Placing a call on hold

•

Call Waiting

•

Rejecting a call

1

Volume

Higher/Lower

3

Charging

Port

4

Main Button

2 3

2

Microphone

5

Adjustable

Ear Hook

Earphone

LED Indicator

6

7

1

1 LED Indicator Light

a) Blue mode indicates active/standby.

•

1 Flash every 5 seconds: Your Bluetooth®
Headset is not connected to your mobile
phone.

•

1 Flash every 7 seconds: Your Bluetooth®
Headset is connected to your mobile phone.

b) Red mode indicates battery level.

•

Flashing Red - Indicates low battery level.

•

Solid Red - Indicates your Bluetooth®
Headset is being charged.

•

Solid Blue - The battery is fully charged.

c) Blue/Red Flashing Mode

• Your Bluetooth® Headset is in pairing
mode

Main Button

2

Volume Higher/Lower

3

4 Charging Port

5 Microphone
6
6 Adjustable Ear Hook

6 Earphone

7

FEATURE DIAGRAM

GETTING STARTED

ChArging your heAdset

Your Just Wireless® Bluetooth® Headset comes with a built in rechargeable battery, and must be
fully charged before using. Use the supplied USB Cable to charge your headset by plugging it into the
charging jack shown below.

•

The red LED light will flash
when you have a low battery
level. It is suggested to
charge the headset at this time.

•

The red light will illuminate solid red during charging and will turn solid blue
when fully charged. It will take approximately 1-2 hours to charge.

•

Your headset cannot be used while charging.

4 5

turning the heAdset on And oFF

ON Mode: Press and hold down the Main Button for 3 seconds. Your headset will beep and the blue
LED light will flash 4 times. Now your headset is on.

OFF Mode: Press and hold down the Main Button for 4 seconds. You headset will beep and the red
LED light will flash 2 times. Now your headset is off.

Standby Mode: To save battery power, your headset will automatically change to standby mode
when not in use. The blue LED light will flash every 7 seconds. The headset will automatically change
back to ON mode, when a call is incoming, or when the Main Button is pressed.