SHI KISB Electronic BTK 605A User Manual

BTK-605A Bluetooth Audio Dongle User Manual

Characteristics:

1. Send the music in the audio devices or PC to Bluetooth stereo headset to enjoy good quality music.

2. Apply to mini-size audio devices and PSP

3. Connect with two Bluetooth stereo headset at the same time

Your dongle overview

Charging the dongle

Your dongle uses a rechargeable battery. You must charge the battery fully before using the
dongle for the first time.

1. Plug the USB cable into the computer

2. Connect the USB cable with dongle as it shown on the picture. The red indicator of headset will turn
on when charging.

3. When the battery is fully charged, the red indicator will turn off.

1) Depending on your country, the travel Charger may appear different from above illustration.

2) When the headset is in low battery, the red indicator would flash twice each 5seconds.

1

3) The headset will be fully charged in approximately 1-2 hours.

4) Remove the travel charger from the AC socket.

WARNING: Do not attempt to charge the dongle with anythi ng other than the travel charger provided.
Using unauthorized travel charger may damage the dongle.

IMPORTANT: The dongle cannot be used while charging.

BASIC OPERATIONS

Please make sure that your dongle is connected with the audio device or PC by plugging
the dongle into 3.5mm earphone jack in the audio or PC.

Turning the dongle on/off

1. To turn the dongle on

Press and hold Power Button for about 2 seconds, the blue indicator of the dongle will flash for 1 second.
The dongle is now turned on.

2. To turn the dongle off

Press and hold Power Button for about 5 seconds, the red indicator of the dongle will flash for 1 second.
The dongle will be turned off.

3. When the blue indicator flashes red, it means the headset is on low battery, please charge the
headset.

Pairing

Before using your dongle for the first time, you must pair it with your Bluetooth stereo headset.

1. Ensure that the dongle is on (see “To turn the dongle on” section). And make sure the Bluetooth
Stereo Headset is under pairing mode.

2. Press and hold Power Button for about 2 seconds until the indicator light alternately flashes blue and
red，your dongle is under pairing mode.

3. Then the dongle will be connected with the Bluetooth stereo headset after few seconds.

If you want to connect with the second Bluetooth stereo headset, please follow the procedures as
follows:

1. Press and hold Power Button for about 2 seconds until the indicator light alternately flashes blue and
red, and the dongle will disconnect with the first Bluetooth stereo headset.

2. Then the dongle will be connected with the second Bluetooth stereo headset after few seconds.

3. Press Power Button twice to reconnect with the first Bluetooth stereo headset.

Connect with two Bluetooth Stereo Headsets at the same time:

1. Ensure that the dongle is on (see “To turn the dongle on” section). And make sure the two Bluetooth

Stereo Headsets are under pairing mode.

2. Press and hold Power Button for about 2 seconds until the indicator light alternately flashes blue and

2