ShenZhen Xinzhensheng electronics CO FM3963R, FM3963 User Manual

FM3963，

，Wii wireless classic controller manual

，，

一一一一、、、、Function Description

Adopting 2.4G transmition mode,powered by 2pcs AAA battery.Exceptly its function
is same as the official wii nunchuk,it also has Turbo and low power indication
function

二二二二、、、、USER GUIDE

（（（（一一一一））））Performance Guide：：：：

1. 6pcs input button：a、b、x、y、ZR、ZL；

2. 3pcs basic function key：SELECT、HOME、START；

3. D-pad button：Up、Down、Left、Right；

4. 2pcs 3D stick ：LX、LY、RX、RY；

5. 2pcs shoulder button：L、R；

6. 2pcs shoulder trigger button:ZL,ZR ；

（（（（二二二二））））Set up Turbo function：：：：

1．Press down Turbo button,then press any button a/b/x/y；；；；

2．During above operation,red Turbo LED will flash.After finishing setting, will

flash red when pressing a \ b \ x \ y by oneself；

3．Repeating above operation if cancel the Turbo function；

4．Pressing fixed fire button solely when playing game,there will be flashed red

LED;if no fixed button,no LED indicates

（（（（三三三三））））How to link

1．Put 2pcs AAA battery into controller,slide switch to “ON” position；

2．Blue LED start to flash when turn-on ,please press down SYNC button,blue

LED on the pads will flash rapidly,begin to search and link；（As attached

photo）

3. Plug the receiver to the end of remote,blue LED at the bottom of receiver will

rapidly flash, after 1 second it will be successfully linked, receiver’s blue

LED will be lighting.When the Voltage is below 2.3V,blue LED will flash

FM3963，

，Wii wireless classic controller manual

，，

slowly,it minds that should replace with new battery;

4．When they be paired well,it will fulfil all the function as official wii classic

controller, operating interface and playing games.The wireless pads will

enter into sleeping mode if the receiver has no signal up to 1 minutes or the

pads has no signal up to 5minutes.And press one of these

buttons(include:Start,Select,a,b,x,y,ZL,ZR,D-pad,L,R,Sync) can wake up.

5. It has memory function,after first paired successfully,it can pair again

automaticly

三三三三、、、、Dims：：：：

Controller:（L）151 *（W）95 *（H）42 mm

Receiver:（L）36mm *（W）31mm *（H）26 mm

四四四四、、、、Caution

1. Do not expose to high temperature

2. Do not disassemble or clean with causticity liquid

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.