Shenzhen MTN Electronics WR-150 User Manual

Wireless Router WR-150

Quick Installation Guide

RECYCLABLE

1

Federal Communications Commission (FCC) Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

This device should be installed and operated with a minimum distance of 20 cm
between the antenna and all persons.

Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
inst a lle d an d use d in acc o rd a nce w it h the i ns t ruc t io n s, m a y c a use harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

z Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications made to this device not expressly approved by
SHENZHEN MTN ELECTRONICS CO., LTD.may void the FCC authorization to operate
this device.

Note: The manufacturer is not responsible for any radio or tv interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.

2

LEDS Description

The Router's LEDs are located on the front panel(View from left to right).

Name Status Indication

Off No Power

PWR

Status

WLAN

On Power on
Off The Router has an error
On The Router is initializing
Flashing The Router is working properly
Off The Wireless function is disabled
Flashing The Wireless function is enabled

WAN/LAN(1~4)

Off There is no device linked to the corresponding port

On
Flashing Sending or receiving data over corresponding port

There are devices linked to the corresponding ports but no
data transmitted or received.

Reset Button

There are two ways to reset the router's factory defaults:

1) Use t he Fa c tory D e faul t s func t ion o n Manag ement - > Sav e /Relo ad Setti n gs pag e in
the router's Web-based Utility.

2) Us e th e Fac tor y Def aul t Res e t b u tto n: Wi th t h e ro ute r pow ere d on, use a pin to press
and hold the Reset button(about 5 seconds) until the SYS LED becomes quick-flash
from s low -fl a sh. And t hen rel e ase t he b utt o n an d wa i t th e ro u te r to reboot to its factory
default settings.

Configuring the Router

In the IE browser,type "192.168.1.1" into the login screen.

Enter you username and password,the default username is "admin",and the default
password is "admin".

After your successful login,you can see the interface as follows:

3

You can configure and manage the router. There are seven main menus on the left of
the Site contents. Submenus will be available after you click one of the main menus.
The seven main menus are: Setup Wizard,Operation Mode,Wireless,TCP/IP
Settings,Firewall,Management,Logout. To apply any settings you have altered on the
page, please click the Apply Change button.

1. Setup Wizard

The setup wizard will guide you to configure access point for first time. Please follow
the setup wizard step by step.

4