Shenzhen MTC Electronics WU-150R3 User Manual

USB Wireless Adaptor User Manual

一、 Network Card Installation

Please follow the following steps to install your new wireless network card:

1. Insert the USB wireless network card into an empty USB2.0 port of your computer when computer
has power on. Never use force to insert the card, if you feel it’s stuck, flip the card over and try
again.

2. Insert device driver CD into the CDROM drive of your computer, double click the ‘Setup.exe’ icon
and run the ‘Setup.exe’ program.

3. Select the language that you are familiar with.

4. Click ‘OK’, then pop up the InstallShield Wizard

5. Click ‘Next’ ,

6. Click ‘Install’, and begin the installation

7. Please wait while the installation procedure is running. Finally, click ‘Finish’ and restart your

computer to finish the driver installation

二、 Connect to Wireless Access Point

1. After installation has finished, wireless configuration utility will be shown on the desktop of your

computer, and it will try to connect to any unencrypted wireless access point automatically. If you want
to connect to a specific wireless access point, or the access point you wish to connect uses encryption,
you have to configure the wireless network card and input the correct password to get connected to the
wireless access point. Double click the icon on your desktop.