深圳共进电子有限公司
WNA699P5G.7 Product Specifications
V1.0
All Rights Reserved
深圳共进电子有限公司
Introduction
WNA699P5G.7, a Wireless Local Area Network(WLAN)11b/g and Bluetooth
The
mini-PCIE Network Adapter, is a high-performance wireless assess tool. It
supports 802.11 b/g and Bluetooth 2.1+EDR Standards, works at 2.4G
frequency band.
The WNA699P5G.7, a utilizes Broadcom’s technologies to improving both
802.11b/g and Bluetooth performance and link stability in real environment.
It enhances user experience in a totally wireless environment, where all
devices are connected wirelessly through either Bluetooth link or 802.11b/g
link. It is suitable for using in a wide range of both residential (at-home)
and commercial (offices, apartments, hotels, warehouses) network
applications.
Features
l Single-band 2.4GHz 802.11b/g with up to 54Mbps data rate
l Fully supports the Bluetooth 1.1, 1.2, 2.0, and 2.1 standards including
1-, 2-, and 3-Mbps EDR operation
l PCI express Base Specification compliance: Rev 1.1
Security: WEP,WPA Personal,WPA2 Personal,WMM,WMM-PS(UA-PSE),TKIP,and
l
AES hardware acceleration
l Programmable output power control meets Class 1,Class 2 or Class 3
requirements
l Support Broadcom SmartAudioTM, wide-band speech,SBC codec,packet loss
concealment,and DSP rata match
l On-chip voltage regulator lowers BOM requirements and provides
additional power savings capability
l Minimized power dissipation over other solutions
深圳共进电子有限公司
Application
l Personnel computer
l Laptop computer
l TV over IP(IPTV)
l Voice over IP(VoIP)
l Higher data rate wireless broadband access
l Network and online gaming
l Audio and Video streaming and transfer
l PC file and application sharing
Hardware Architecture
深圳共进电子有限公司
Product Photo
Mechanic Drawing
Full Size
深圳共进电子有限公司
Software & OS Support
Driver
OS Driver
Windows XP Available
Windows 2000 Available
Windows Vista Available
Linux Available
Operating conditions
Voltage Range
3.3V±0.3V
Storage Temperature Range -20
Relative Humidity During Operating 95% (Non-Condensing)
Relative Humidity During Storage 95% (Non-Condensing)
Antenna Connector
Connector Vendor Number
Antenna I-PEX WIFI*1;Bluetooth*1
0℃---65℃
℃---85℃
深圳共进电子有限公司
802.11 Wireless LAN
Ø Modulation Methods
Ø Channel Assignment
Note:
US=United States, CA=Canada, EU=European Countries(except France and Spain),
JP=Japan
×=Supported
深圳共进电子有限公司
Ø RF Characteristics
RF Characteristic Minimum Typical Maximum Units
PC Interface PCI-E
Plug and Play Compatible Yes
Internal Antenna Impedance 50 ohms
Operating Temperature Range 0
﹢65
Storage Temperature Range -10 +85
℃
℃
Supply Voltage 3.0 3.3 3.6 V
RX Sensitivity, 11Mbps(CCK) -88 dBm
RX Sensitivity, 54Mbps(OFDM) -74 dBm
TX Power(CCK) 18 dBm
TX Power/EVM @54Mbps 16/-30 dBm/dB
TX Carrier Suppression PASS
TX Spectral Mask PASS
Frequency Error PASS
Bluetooth
Ø Modulation Methods
FHSS(Frequency Hopping Spread Spectrum)defined in Bluetooth Specification
Ø Channel Assignment
深圳共进电子有限公司
Ø RF Characteristics
RF Characteristic Minimum
50 ohms
Operating Temperature Rage
RX Sensitivity@πGFSK,2Mbps -78 dBm
-DPSK,3Mbps
3.3
-78
-72
V
dBm
Unit
℃
℃
-15.4
-20
m
深圳共进电子有限公司
Pin Definition
Pin# name Pin# name
51 NC 52 3.3V
49 NC 50 GND
47 NC 48 1.5V
45 NC 46 LED_BT
43 GND 44 LED_WLAN
41 3.3V 42 NC
39 3.3V 40 GND
37 GND 38 USB_DP
35 GND 36 USB_DN
33 PCIE_RDP 34 GND
31 PCIE_RDN 32 NC
29 GND 30 NC
27 GND 28 1.5V
25 PCIE_TDP 26 GND
23 PCIE_TDN 24 3.3V
21 GND 22 PCIE_PRST_L
19 NC 20 RF_DISABLE_L
17 NC 18 GND
15 GND 16 NC
13 PCIE_REFCLK_P 14 NC
11 PCIE_REFCLK_N 12 NC
9 GND 10 NC
7 PCIE_CLKREQ_L 8 NC
5 BT_RFCTRL 6 1.5V
3 NC 4 GND
1 PCIE_WAKE_EL 2 3.3V
深圳共进电子有限公司
Safety Information
In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be
installed and operated with minimum distance 20cm between the radiator and your body. Use only
with supplied antenna. Unauthorized antenna, modification, or attachments could damage the
transmitter and may violate FCC regulations.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
IEEE 802.11b/g operation of this product in the U.S.A. is firmware -limited to channels 1 through
11.
This device is intended only for OEM integrators under the following conditions:
The antenna must be installed such that 20 cm is maintained between the antenna and users, and
The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Loading...