ShenZhen RC100 User Manual
Wireless Charger
Product Introduction
Product Outline
RC10 0
User Manual
FCC ID : 2A O SU R C1 00
1
Wireless charger RC100 is an intelligent product. There is no need to plug
your phone‘s charger port in or out. Just simply place your devices on RC100
pad and you are free to enjoy your wireless and limitless charging experience
now!
2
PowerInput
LEDindicatorarea
Anti-slipperyRubberband
3
Applicable Devices
iPhone X/iPhone 8/iPhone 8 plus, SamsungGalaxyNote8/Note5,
S8/S8+/S7/S7 edge/S6/S6 edge/S6 edge+,GoogleNexus 4/5/6, LG V30
and more.
Instructions
1. For best charging on sweet spot, please use 2A adapter (NOT INCLUDED) or
Original adapter and cables.
4
2. Connecting power with USB port, the indicator
will flash for seconds when power is on.
3.① Locate your phone on charging pad and make
sure it at sweet spot for effective charging.
②Whe n the p hone i s cha rged s ucce ssf ully,
the LED in dica tor w ill fla sh for 3 0 sec onds
then off to keep t he who le ch argi ng pro ces s
sleep- frie ndl y.
5
Package Contents
Wireless Charger(RC100)
USB cable
User Manual
Product Specification
Input: 5V,1500mA
Output: 5V,1000mA
Charging Distance: ≤10mm
Charging Efficiency: ≥73%
Size: 89.6mmX8.4mm
Attention:
1.Keep the charger away from water and other liquid.
2.Please make sure the power is cut off before you start to clean
the charger.
3.Use the charger under temperature only between 0-45°C.
6
FCC StatementFCC Statement
The device complies with part 15 and 18 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device has been tested for human exposure limits and found compliant
at a minimum distance of 10cm during operation.Thus during the operation of device
a distance of 10cm must be respected in every direction.
Loading...