Shenzhen NAS-PD02Z Instruction Manual

Instruction Manual

Motio

n Sensor(PIR)

Model Name: NAS-PD02Z

Thank you for your support

 Please read the instruction manual carefully before operating

 Please keep the instruction manual after reading

Shenzhen Neo Electr

onics Co., LTD

Product Introduction

PIR is a passive infrared detector or physical sensor, the sensor doesn’t emit any energy but only
passively receive and detect infrared radiation from outside. Under room temperature, all items
have radiation. Human beings are warm-blooded animal with stable infrared radiation, are most
easily to be detected. That’s why we also call it body sensor. PIR send messages via Z-wave
network to the Z-Wave main controller. In the Z-Wave network communications, PIR can be
connected to any Z-wave main controller,Different countries or areas, the radio frequency is
different of the Z-wave network. In the communication between the PIR and Z-wave main
controller, PIR can only send messages, not be able to receive messages. When the PIR is
triggered, PIR will send message to the Z-wave main controller, and associate devices to work
through the Z-Wave main controller. The PIR is battery powered, is small and can be installed
easily.

Technical Parameters

 Power supply: CR123A x 1
 Standby current: 15uA
 Battery life: 7 years
 Radio Protocol: Z-wave



Radio Frequency: 908.42MHz

 Detection range: 7 meters
 Viewing angle: 90 degree
 Operation temper: 0-40℃
 Storage temperature: 0-60℃
 Size (D x W x H): 45mm x 45mm x 48mm

Technical Information

 Use passive IR sensor to detect what is moving.
 When the PIR is triggered, LED light flashes in the detection area.
 Easily install with screws or sticker on the wall or the table.
 When there are people or animal that is moving in the PIR detection area, PIR

will send alarm messages to the Z-wave main controller.

 Compatible with any Z-Wave main controller.

Product Configuration

Product List

 PIR 1pc
 Holder 1pc
 Battery 1pc
 Screw 2pcs
 Screw stopper 2pcs
 Sticker 1pc
 Instruction manual 1pc

Code button

Holder

Sticke

r

Screw

Battery

Screw stoppe

r

LED light

Inductive area

Including Sensor (PIR) to Z-Wave Network

The PIR can be included to the Z-wave network by pressing on the code button.

1) Disassemble the PIR main body and insert the battery into the contact sensor. Make
sure the device is located within the direct range of the controller.

2) Set the controller into the learning mode (see mail controller’s operating manual).

3) Quickly, triple click the code button, LED light will flash red for 5 times.

4) PIT will be detected and included in the Z-Wave network.

5) Wait for the main controller to configure the PIR.

Excluding Sensor (PIR) from Z-Wave Network

1) Make sure the sensor is connected to power source.

2) Set the main controller into the learning mode (see main controller’s operating
manual).

3) Quickly, triple click the code button,LED light will flash red for 5 times.

4) Wait for the main controller to delete the sensor.

Installation Steps

 Holder Installation
 Battery Installation
 Fix PIR on the holder

Holder Installation
Option One Option T wo

Fix the holder with screws and screw stopper Fix the holder with double-sided
adhesive