Shenzhen MD-3010? Instruction Manual

MD-3010Ⅱ

INSTRUCTION MANUAL

CONTENT

1. INTRODUCTION

1.1 FEATURES OF YOUR DETECTOR

2. PARTS AND NAMES

3. PREPARATION

3.1 ASSEMBLING THE DETECTOR

3.2 INSTALLING BATTERIES

3.3 BATTERY CONDITION INDICATION

3.4 USING A HEADPHONE

4. OPERATION

4.1 CONTROL PANEL

4.2 LCD DISPLAY

4.3 OPERATION INSTRCTION

4.4 SEARCH TESTING

4.5 OPERATION TIPS

4.6 METAL DETECTOR OPERATORS ETHICS

4.7 PLACES WHERE YOU CAN USE YOUR METAL DETECTOR

5. MAINTENANCE

6. SPECIFICATION

1. INTRODUCTION

Thank you for purchasing our metal Detector. With this powerful and versatile device, you

can hunt for coins, relics, jewelry, gold, and silver just about anywhere. To obtain

maximum performance, The detector is versatile and easy to use with LCD. We urge you

to take a few minutes to read this manual carefully and retain this manual for future

reference.

FEATURES OF YOUR DETECTOR

Fully Automatic and All Metal Detectors - Your detector detects all kinds of metal

objects. Unless you have set for some objects that you don t want to detect.

LCD The LCD with light, it improve to identify the metal in night or caliginous outside.

Target Identity: The detected objects are shown on the LCD display. You can decide

immediately if the objects worth to be recovered.

Unwanted Target Elimination - You can set the detector not to respond to some objects.

Unique Tone for Target - You don t have to keep watching the LCD display, when an

object is being detected, an unique tone corresponding to a target will generate. You may

even searching when there is little or no light.

No Clumsy Slack Cable - hidden search coil cable (connecting between control unit and

search coil) avoid entangling and for ease of stem length adjustment.

Headphone Jack - provided for headphone connection. Both stereo or mono headphone

can be used.

Volume Control - for adjusting the output volume to the loud speaker or headphone.

Batteries Condition Indicator - shows the conditions of the batteries in the battery

compartment.

Waterproof Search Coil - lets you use the detector in the shallow water.

Adjustable Stem - lets you adjust the detector s length for comfortable use. The

micro-plug that connects the search coil and the controller unit is made of metal which

makes the plug more reliable.

Armrest & stem - designed to eliminate strain on forearm. The nylon bracket to further

secure the slip of the hand compartment after long time holding the detector by arm.

Power - Use six 1.5-volt AA alkaline batteries.

2. PARTS AND NAMES

NOMENCLATURES:

3.1 ASSEMBLING THE DETECTOR

You don t need any special tools to assemble your metal detector. All you need is a small

Philips-head screw driver. After unpack your detector, you may start the following

assembling and adjustment:

3.1.1 Rotate the STEM LOCK NUT（11）Clockwise until loosens.

3.1.2Slide the UPPER STEM (12) towards the SEARCH COIL (14) as indicated by an

arrow until you can see a micro-plug metal connector. Pull out the plug so that you can

hold it on your hand.

3.1.3 Locate the micro-jack connector in the HANDLE ASSEMBLY (6). Connect the plug

and the jack together and care of alignment marks showing on the surface of the jack and

plug.

3.1.4 Slide the UPPER STEM (10) towards to the CONTROLLER UNIT. Cares should be

taken for the direction of the cut slot (of the upper stem) which should be pull underneath

the support of the controller unit.

3.1.5 Tighten the KNOB NUT which is located under the CONTROLLER UNIT (7).

3. PREPARATION