Page 1
Bluetooth Speaker Menu
Operation Image:
Product picture and Fuction
1.MODE switch (Bluetooth/Micro SD card)
Press once to switch Bluetooth / Micro SD card mode
2.“ ” Next clip / Volume Up
Press once to next clip, press & hold to volume up
3. “ ”Previous clip / Volume Down
Press once to previous clip, press & hold to volume down
4. “ ” Play / Pause
Micro SD card mode: Play / Pause
Bluetooth mode: Play / Pause/answer & finish phone calls
Page 2
5．AUX Audio in
3.5mm external audio in
6．Micro SD card slot
Insert Micro SD card to play music,supports tops 16G
7．Micro USB recharge slot
Plug in Micro USB cable to recharge the device
8．Microphone
Facing microphone direction to answer phones calls improving the phone
singal stability
9．Speaker
Stereo speaker audio out
10．Recharge the battery
Plug in USB cable and use specified adapter to recharge the speaker
Attention: Insert audio cable in any mode system the speaker can identify
and turn to AUX input audio mode automatically.
Specifications:
RMS Audio Power: 5W*2
Distortion: <0.1%(1K/1W/3.7V)
SNR: ≥ 85db
Frequency Response: 50HZ--18KHZ
Speaker:52mm
Bluetooth standard specification:V2.1+EDR
Bluetooth agreement:A2DP1.2
Bluetooth frequency:2.402GHZ-2.48GZH
transmission range: 10 meter
Input power: Input DC 5V/500mAh
Power: 3.7V
Product size: 220*68*74mm
Page 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...